• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Recent content by sullyd

  1. Question Oce Arizona 360gt Problem

    UPDATE** problem resolved... two pronged , new firewire cable and new brushes to motor.... managed to fit ourselves as latest prices from Oce on a call out is £550 (first hour) £66 per 30mins thereafter. Firewire cable £120 plus vat , Brushes , £620 plus vat , all payable in advance. I found two...

  2. Question Oce Arizona 360gt Problem

    Hi I have a machine that when i have reset the Gantry system goes up but then will not come down ready for print. I have looked at the rails (all clean) and the motor lights are on but go off when it stops in the up position.Message given is the normal gantry motion error but cannot see any...

  3. ink vacuum system error

    Hi All any ideas? i have walked into this today. error saying ink vacuum system error with no yellow heads. any pointers would be good.

  4. Arizona 350gt problem

    update Thanks Pat have tried the brushes but all looks fine in there and did the head carriage thing. looking at it now its coming up with an internal communication error after doing one pass and then on the reset it says Z axis error and fails to reset unless machine gets powered down. Have...

  5. Arizona 350gt problem

    Hi All need help with a problem z axis fault on console , yet head is all correct and set itself up fine. when machine passes left to right it dies , guard error will not reset itself until machine is switched off and back on again. anyone know anything to check before i call in the money men!
See more
Top