Recent content by Suntex

We recently had our JV5-320S serviced for the contamination. We were told that because of our ink switch, that the old ink has damaged the head from 1 year ago. Yet all our JV33-160 are fine, they just needed new dampers. The sad part of this story is that the JV5 is by far the newest printer...

It turns out, it was the Flushing Box Filter Exchange. The JV5 had an error the next day for Error 145, which in the Mimaki manual said the Flushing Box Filter needed exchanged! All good to go!

We have a JV5-320S that after every panel will go into Local, we then have to manually push the Remote button to start the next panel. This cannot happen because we need to be able to print overnight without babysitting the printer all the time. Any ideas? We use Texprint 14 Ergosoft RIP with...

We finally fixed the problem JV33!! After all the problems it had, we ended up replacing the motherboard, data cable, printer head, dampers and capping station. The last 2 130 yard rolls we printed finished! Thanks again for all your help.

We tried the new motherboard in the JV33 printer that kept stopping and so far so good. The only issue it has now is the head was sitting for so long that it will not print without dropping out, so now we need to replace the print head. Will update when we finally get the new head and try to...

We tried replacing our USB cable from a a different printer that was working properly, but it didn't fix our printer from stopping.

We used those Blow Off cans of compressed air for electronics. It didn't fix our problems though :(

The Errors we are getting are "Error sending data to device, Error -53634661" Error 1117, Error sending data, Request could not be performed because of I/O device error" "Error -31, Device attached to the system is not responding." We are still waiting for the motherboard to arrive.

We opened the cover to the motherboard today and found alot of dust trapped in the cover and on the board. After eliminating the dust, we did some yard tests to see if it would finish them and it did. Unfortunately after trying to run a full roll of paper, it stopped approx. 10 yards in or not...

After the clean install we were printing for a few minutes and the problem JV33-160 displayed an "Error 1111, I/O Error sending data". A tech is coming to install a new motherboard in the printer to see if thats the problem. At least all our USB are displaying Hi-Speed 4800mbps now instead of...

First new fix We have reinstalled Windows and TexPrint today and going to try running with it. If this fails we are prepared to buy a new PC. This PC has been a problem from the start, it came with bad RAM, it has crashed and locked up overnight, it has needed constant maintenance to keep...

We recently upgraded to TexPrint 14 with 2 ErgoSoft RIPs. After about a months usage, one of our JV33-160 refused to continue printing a full roll of paper. Our main RIP is running 5 printers, and our Print Server normally would run 2. We have been on the phone 3 days constantly trying to...

We recently upgraded to TexPrint 14 with 2 ErgoSoft RIPs. After about a months usage, one of our JV33-160 refused to continue printing a full roll of paper. Our main RIP is running 5 printers, and our Print Server normally would run 2. We have been on the phone 3 days constantly trying to...