I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Thank you for taking the time to clarify.
Is there any way for me to pull a list of what all this can do?
Would the best place to sell be ebay or perhaps the classifieds here?
I have a copy of Onyx Thrive 19 221 I no longer need.
What is a reasonable price to ask for this?
I can't seem to find any consistent answer to this question.
In the years that I have used Roland cutters I have found that the amount of blade that is exposed has not been nearly as important as pressure.
Before you send you job to the printer, load the material you want to use (or a scrape piece) press the "cut config" button on the XC-540 control...
I have a XC-540MT that had a blown Transistor on the Head board (TR12). I metered all of them to find the faulty one (I did this by checking for a short across any two legs of each transistor)
I replaced the shorted Transistor but I am still getting a very high impedance reading on the new...
We can do that order for $677 out the door.
My name is Justin here is my info. Give me a call if you have any questions!
Justin Schacknies
MakeKings LLP
401 S. 1st St.
Ponca City, OK 74601
580-304-9153
I'm in Ponca City and I can handle it. Let me price this out and get back to you with a quote. There is a good chance I'll just drive the order down to you.... I have been needing a good excuse to head down that way.
Man oh man I am soooo glad I read this today! I have been doing this all wrong and not realizing the issue! I have a dual monitor setup and show proofs "on the fly" and I have had some LIFE SUCKING nit pick sessions.
I'm bout to go put this second monitor on craigslist!
Thank you!!!
I don't want to over simplify a real issue, but I always am guided by a few simple yet hard to execute principals.
1. People First
2. You can have control, or you can have growth. Not both...
Hit up your the rep for Arlon in your area. They have 2 versions that will work DPF8000 and DPF8200 (low shrinkage). Ask for a sample roll. They sent me both. It's stupid tacky. I have not used it for hdpe yet but I'm confident it will stick to it. They specifically list it as a compatible...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.