I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
It turns out the head was shot. Using a syringe a purged cleaning solution through the yellow damper and into the head - being careful not to apply to much pressure. The fluid never cleared up it just kept leaking cyan. The baffle, or gasket between the cyan channel and yellow channel in the...
I let ran a nozzle soak for 4 hours - still no yellow. I replaced the capping station a couple of months ago so it's pretty new, and I just replaced the yellow damper last night to see if that took care of the problem. Before I pulle the old damper I could see the tiniest bit of green inside the...
I'm searching throught the past forums for answers but wanted to see if anyone has suggestions in the meantime. MYJV 33 printhead began printing the wrong color on one channel. In the middle of printing - it looked liek yellow had dropped out. I stopped the pring and did a test draw - all...
One that can handle 100" media - we're not set on a brand yet. We've looked at a couple of Italian made heat presses but wanted to see what else we might find before we buy new.
We use the Brightline vinyl with our Mimaki. Included with our Rasterlink III were 3 or 4 color profiles - one of which is for 3Mij160 which will give pretty good results. It's not the one we use daily but off the top of my head I know it works.
Does anyone know of or have a used heat transfer press or a heat setter for sale? I am looking for something to compliment our 102" Mutoh dye sub printer. I have been watching a few sites such as Global Garage and I have not seen anything I'd like to buy yet. Any thoughts?
We chose the H650 simply because we got a good deal on a demo that was practically new. I will be printing on it tomorrow and the rest of this week so I will have a much better feel for it in a few days but so far I am happy with it's ease of use - and the rip software is great.
Just started the install! The Grimco rep arrived today to begin the setup. I'll post some pics of samples and give some feedback on the printer once we are up and running.
I'll be there!
I'm not sure where we are staying yet but it will be a busy couple of weeks for me - I'll probably be in Vegas for about 10 days supervising set ups and tear downs for the show.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.