Recent content by Tom

I have a classic Edge and a HS15 plus plotter, but the plotter is acting up and I think it's done. I am running Omega software. I'm looking into a new Graphtec plotter, but can't find anyone that is cutting their Edge prints with anything but a Gerber plotter. I really don't want to buy a new or...

Signs 101 Network RegistryIn what country are you located? usa In what state or province are you located? ny In what city or town are you located? Port Chester What large city is nearest you? New York Check all items that apply to your listingInstallations (Basic, no permits)...

Try Orbus http://www.orbus365.com/graphic-services/

My test prints have looked like that since I bought the machine (Used) 4 years ago. I replaced the pumps, did all cleaning options, etc. It really has not affected my print quality... If you do get it corrected, you probably won't notice a difference either.

Once you decide on a software bundle, check out www.needsoftware.com As a student, you can get BIG discounts on full versions or academic versions. BTW... I'm partial to CorelDraw... My 2 cents...

I've used a couple of PVC post and panel frames from: http://www.thenewkit.com/index.html They are OK, certainly not heavy duty, but good for the right application. Good Luck!

Well, I'm able to print, thanks to a 6' USB cable, but I do have a computer issue. 1 of 3 Hard drives failed. It may be a controller or the disk TBD. Time to upgrade.....

I un-installed and re-installed Versa Camm Drivers and Colorip with the updates and still have the problem. I can bump the RAM from 2GB to 4GB, so I'll try that next....

Cut only also stops after a few seconds. I replaced the main ribbon, and still the same results.

USB connections are OK. I tried changing the cable, same results. The ribbon does have 2 small kinks, Ill try replacing it. I don't get any error messages at all. It just goes to "Now Processing" and hangs. Thanks for the help!

I'm running an SP300 with colorip 2.2. Everything has worked well for years. I ran a small file yesterday that just stopped mid-way and the "Now Processing" message appears and hangs. I let it sit for 15 minutes with no activity. I've tried to re-boot, re-rip the file, send a different...

Try Grimco...1-800-542-9941 - I'm not sure if they can do it, but they are worth a shot.

How did anyone even find this thread to reply to it? It's from 2006! I admit, it was lazy on my part not to do more research before asking that question. I just wanted to get a quick reply from people with more experience. Isn't that one of the functions of forums like this? For the...

Once you convert the original to curves, remove the stroke, use the contour tool to replicate the stroke, then break the contour apart and remove the original graphic.

Thinking back to when I got into this business in 1990, I would have been SCREWED if I just started my own business back then. I worked in Graphic Design for printed media from 1980 - 1985, learned computer graphics and basic layout. I took a break from that for a while, and then took a...