Search results

This is really strange. Do you use Versaworks to print? Have you done a nozzlecheck immediately after it prints with banding?

I found it... 2x 420-024 wheel segmented 2x 420-025 wheel full 4x ND50200-9995 4x ND50000-9008

Hi, you either need to replace cassette roller(s). That's relatively easy and shouldn't cost too much. But it's likely those driven rubbery wheels in the carriage, that turn brittle and eventually even crack.(I can't find the number in the SM and my mail archive was deleted, when we needed to...

1000011069 Oj-535s-a5

Cutting sheets is not working with HP800. Well, cutting works, but the following print will at least smear in the curing unit, if it doesn't produce a head crash...

I'm not sure, flushing out the pigments is enough. For the tubing and dampers it works. With some heads, there is a storage solution inside, that needs to be flushed at installation. (Roland and Mimaki for example and I haven't seen such storage or maybe testing solution advertised) II was never...

If the cleaning pumps have never been replaced, they are highly likely over their 200000 cycles...

To use OPOS CAM, the recognition of the marks is done on the PC by a software called "camera control" on the old S-Class cutters. On the actual S2 cutters, you'd need to run cutter control for mark recognition. You could install Winplot for cutting and use the Gosign Tools (Plugins) to create...

Sounds like blade initialisation, to me. This is done, for the cutter to have the blade in a defined direction. It's normally done, when you load media. Looks like flexi sends a init command with every job. Not sure for flexi, but most cutting software lets you customize this.

Check the OMAS function and the media sensor in the back.

There is no alternative for the thin, opaque and stretchable latex white... The early HP 700/800 are a Royal PITA... I know, I service them. Have the enhancement kit installed and give it a chance.

Optimizer head

Officially, you shouldn't need to adjust the capping position. There is a jig/tool to mount the cap mechanism correctly, but I have never used or seen it. It could also be the plastic part right of the cap, where it gets pushed by the head bracket. I would definitely check the capping...

Are you using original ink/parts? Sounds like the captop isn't making a good seal.

Nozzle test and printing direction would be helpful. One looks like bad adjustment or carriage crash, the other like printhead needs replacement.

I had cases with crystallisation of the yellow ink. In this case I flushed the yellow ink line with cleaning solution, replaced the yellow cartridge and replaced the damper.

I use a tooth brush with alcohol, where I shortened the bristlesl. Don't use a metal brush, as it will destroy the micro sprockets on the rollers. Take care not to spray alcohol into the bearing blocks. 36deg. Is standard for Summa/HP cutters. Offset is 0.43. RTFM as well...

The Opos sensor is only lowered onto the medium during mark recognition.

The pinch roller sensor.

I had a case with a Roland, where the white plastic wheel right of the solenoid had a crack. This is a possibility in a oldtimer...