Search results

Respectfully disagree. Marquee letter boards are pretty classic (and a hell of a lot more classy than LED message boards will ever be) http://tinyurl.com/75jzyvd Great job!

Can you tap the holes first with a very thin nail? Then, use progressively larger drill bits, always concentrating on level entry?

No worries - thank you for taking the time out of you day to help us out.

Thanks again for your time Mooch - Sorry for the confusing simultaneous posts. I checked/unchecked those settings and sadly had the same results.

I just create an arbitrary cut file with registration marks to verify that it was not the file. It consisted of 12" x 30"" box, with registration marks. It recognized the first registration mark fine (miracle). Then, only advanced 8-8.5" to look for second mark, instead of the 31+" necessary.

Thanks for any help you might give - Here are all four screens in Cutting Master.

The main screen in Cutting Master?

We are having an on-going print cut battle - This is our latest problem: For some reason, after successfully reading the first (of 4) registration marks, it only advances 13" or so in attempt to read the second mark. In this case, mark 2 is approx 52" away. Again, on the rare occasion we...

Anyone have a rough idea of total square footage? http://www.scion.com/cars/iQ/

(after three months, I am just regaining the feeling in my finger tips :) Rapid Remover + patience. Good luck.

Yes. On an entire RV.

...which we call: Lamdo Calrissian. This is our first real laminator, purchased from Advantage. It took a little bit of time to translate instructions during set up (pretty poor technical writing). But after set up, we were laminating long sheets perfectly within 30 minutes. A genuine...

This morning it happened on our free HP Permanent adhesiveness gloss, but it has happened on 3951 as well. It also happens on 13 ounce ultra flex banner. I will monitor the environmental numbers more closely as things are definitely heating up in SC. But today, the humidity is 49% and room...

As if material gets much to hot while print job is starting, warps material and catches head. Non-stop.

...can suck it. It takes me about 30 tries to get the damn thing to read registration marks. Today, it won't read. But instead of returning to it's origin point, it cuts a diagonal line across the entire print. What gives?!? Carry on.

best of luck.

Anyone have a cost effective method (or table-top cutter) for trimming 1/2 foam core? Not the bulk of our jobs, but need a decent trimmer anyways.

Thanks. Hoping for some more feedback - Have a great weekend.

Thinking about pulling the trigger on the 63". Thoughts?

too fast. too furious.