Search results

And... we have a winner- vivaldi works. Thank you both- gene

Anyone recognize this? Design by a real designer that needs to be redesigned by us non-designers. Thanks Gene

Huh?

Thank Dog I made my fortune before the downturn. :ROFLMAO:

You are the man. Thanks Gene

Anyone? The truck shop in the deep south claims it is 'bad habit 71' but I can't find anything for that. Thanks Gene

I believe that PS CS5 has something very similar- have not used it. I have used the Fluid Mask trial and was impressed. Gene

I am assuming we are talking about screws here? Remove and replace

Got it this morning. Flush.

Hi Matt- I have Wasatch 6.1 or 2 that I bought for my VP- never got it to print without banding before spring when I had to go into production. I finally switched to Vworks as I had run out of screw around time. I always liked Wasatch on my SP300, better than I like VW now. I have to assume...

Tape hem all 4 here and grommet- unless very temp then a piece of power tape on the back to reinforce grommets. Only tape failure I have had was a pole pocket hung at the top of an arena with no grommets. I assume it got real hot up there- probably would have held with a few grommets for...

Anyone? This guy just had a stroke and I would like to help him out. Thanks Gene

Would someone share a profile with me (actually for the gent that bought my SP300 from me) for this setup- I always used Wasatch rip when I had it and don't have one for Vworks. Oracal or 3m or whatever media will get him closer than he is. Thanks Gene

I have a Fletcher 3100 which works great for coro and lighter plastics but couldn't handle dibond. How much effort to cut a 4' dibond panel? After looking at the pictures- it appears that there is only one cutting wheel? And a different one for .040 alum? The Sawtrax uses a cutting wheel on each...

I just got a Sawtrax email and noticed the ACM cutter- anyone have that? I cut 18 sheets of dibond last week for a (big) tradeshow display and what a mess- and then have to sand the burrs off. Wondering if that works as advertised- the women in their videos seem to have a little trouble...

Originally I used 3/8 round stock with drilled alum blocks for the corner pieces (same for the back)- I upgraded the front side pieces to .5" to support the heavier and heavier rolls that I am printing. A drilled plastic block bolts to the machine frame so they slide in and out easily for...

My HP 2605xx is almost 4 years old and I have fed it countless toner carts- either it is crapping out or the magenta cart I just put in (OEM- altough I use non-OEM also) is bad. I have been thinking that it is reaching the end of its life for a while so I don't want to spend another $90 to...

Another thought Matt- I don't see a forward/reverse switch on the ebay unit? Gene

Matt- are you using the ebay takeup system? Jeff from Xpress was in a couple days ago and he is getting the RealPro system from supply55.com in is going to bring it by. I knew I had seen something similar and in searching found this old thread. Thanks Gene

And the winner is.... Shovelhead. Rex- I also came up with those two - close but not quite. Thanks to you both. Gene