Search results

Nice job, Foam by Design made it happen for you. However, as already mentioned the text spacing is very tight, to close the edges, could have used selective (negative) kerning and given the text some breathing space at the edges, see attached photo. It always helps to make scaled CAD drawing...

If you are printing in CMYK as mentioned, then of course any RGB placed image will print differently (different color gamut) than if it was printed in an RGB color space as intended, so I would convert the RGB image to CMYK before placing it into the CMYK document. Keep in mind converting...

You might want to do a search, there was a thread recently about magnetic sheeting for the last several years NOT being as strong as in the past and some failures on parts of the rolls. Also, Mosh is correct, in the quest to get better fuel millage, vehicles manufacturers have reduced the...

Rumor has it that there will be a new Cuda for 2015, the SRT Barracuda! http://www.caranddriver.com/features/2015-srt-barracuda-future-cars Can you see this as a new black & white interceptor for the highway patrol? :rock-n-roll:

Now you can download Oracal OraColor™ vinyl color palettes into your sign making and graphic design software. If you have one of the software products listed below, select that product, and download a set of Oracal's popular color palettes. CADlink™ Corel Draw® FlexiSign® Adobe Illustrator®...

:goodpost: Exactly, the first part of the roll has been handled and finger printed, small dings, etc. Best to discard the outer part, I would bet, Oracal gives you that 18" for FREE, although I have never actually measured the 50 yd roll, I assume they give you a little extra. Whenever I...

Yep!

:goodpost: Bob, very good explanation... :notworthy:

Here is the Ninja logo in the Kawasaski GREEN per the Kawasaski website. Both in PDF and Jpeg. Hope this helps. :smile:

Dictator or dollar taker, don't know which is worse? :help

As others have said, it's NOT the media, most will have the same problem in the warm environment you are working in. You say you do have "coverage", well if that is like a large carport, you could drape 4 mill clear plastic around all four sides leaving a overlap at one location for access...

Yep, to much white SPACE in the logo, I would change that so the background image fill those large spaces. Not a fan of the yellow, however over all looks good. :thumb:

:goodpost: I searched Google for info on a database called KiM thats is used in FileMaker, nothing - no luck. Please PM info to me, thanks... :thankyou:

That's a good one! :ROFLMAO: :ROFLMAO: :ROFLMAO:

Ok, after all this effort did get the JOB? Were you the lowest bidder? :help

I was talking about TWO issues, first as mentioned, very hard to contour cut with 100% accuracy, I enlarged the OP image to 24" wide and at that size the verticle stroke on the letter "N" is LESS then 1/10th of an inch wide, hard to cut that dead on. And the second part is, printed vinyl...

I would print and contour cut the whole image only as a large block if all the vehicles are WHITE so the background matches. I don't think the very narrow (thin) vertical strokes in that type face will hold up as a separate printed and contour cut application. So, knot knowing the...

Don't know. Where is Addy? :help

Good Job - fit the vehicle well. You get another at-a-boy................. :rock-n-roll:

Tiki - Thanks for the link, I downloaded several nice FREE fonts, as a designer, I can never have enough FONTS....:rock-n-roll: :thankyou: