• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Search results

  1. Question regarding installing Omega/Rainbow Sentinel

    Gary if you have any software on that computer that uses an aladin dongle that is why you have the Rainbow Sentinel Driver!

  3. New from Delaware.

    What model Graphtec? Are you sure you have the correct driver installed in signlab? Do you have it set to the correct language? HPGL or GPGL?

  4. FOJr. Black boxes across the heater LCD, HELP!

    check power/fuses!

  5. Design Contest - Death Metal Poster!

    I know Isign I was just throwing a dig at you:thumb: I think the last contest the one arranging it put down true deadline!:rock-n-roll: Good Luck!

  6. Design Contest - Death Metal Poster!

    Isign you are always trying to get more time on these:)

  7. greys are greenish

    This is one of the reasons to print out color charts! This way you know the colors you can reach and match!

  8. Packing up for a move

    Once ink is in the heads it is pretty hard to get it all out, but your best bet is to flush with cleaning solution, run some test strips of the colors to try and get them to print clear! then flush and shut down!

  9. Crop marks ?

    In Corel if you open the print dialog and go to the prepress tab there is a box for registration marks and you can use the ones shown or create your own! If you create your own make sure you use the color registration mark!

  10. Hello all from NH

    Welcome to the forums from PA.....! Come on Gino quite taking those nips and start paying attention!!!:)

  11. Graphtec CE5000-60

    What is your cutting software? If you are trying to cut straight from Corel you will need the windows driver! Other wise the cutting software should have the driver in it and needs to be configured correctly!

  12. help for clear cling

    Depend what you are printing with! You do not have your equipment listed in your profile!

  13. Fred Weiss - Where are you.......?

    I would check to make sure the cutting head lift mechanosm is clean and lubricated! It could be dirty and not lifting all the way!

  14. Q100 Load Media!

    Only if there isn't enough on the roll!

  15. Edge FX ethernet failure

    Try to ping the Edge FX IP address!

  16. Hello from Sarasota FL

    Welcome to the forums from PA......

  17. hello from IL

    Welcome to the forums from PA......
  18.

    UFG Design Contest Results

    Congratz Joe, and good work every one!

  19. Please Help "Cannot Open Port"

    Try turning off you firwall! If this causes it to work then you need to add an exception!

  20. CorelDraw not linking to PhotoPaint repair

    Yea I know Rep. that why I posted it! If I remember correctly some people were having issue earlier!

  21. CorelDraw not linking to PhotoPaint repair

    Here is a link to fix CorelDraw not linking to PhotoPaint! This fixes the registry entries to get it working again!
Top