Search results

I concur

Did they new dll file worked? Please Advise :popcorn:

You will have to have 6 cartridges. :Welcome:

Typically these coating are for aqueous ink sets and do not let the eco inks dry or absorb ink properly.

You do not have to, do it just like Caleb said. Not sure what version of the Service Manual you got It should be on Chapter: 4.9.4 Replacing Maintenance Assembly

The trick it's Avoid printing on Magnetic... Printing magnetic media on the VJs is NOT a recommended application. The VJ’s all have a ferrous preheater surface and the magnet will stick to this and cause excessive drag on the media and perhaps on the drive itself. One single head strike and...

Is it connected directly to your PC or Are you running through a hub, switch or a router?

Yes it will...

PM Sent

PM me with your email and I'll email you the dll file...

I would suggest you getting Just the RIP (Photo Print) instead of FlexiSignPro since you already have Corel

When pushing the heater buttons up and down, does it beep ? Check the control panel cable from the CP to the mother board, normally the most common culprit. It could also be the heater control panel board.:rock-n-roll:

I normally take the MSA out, then you have plenty of room to clean

That's crazy, I normally cut from CS2, I just intalled just to see if I get it working on my X4 and it worked. Does it give you the same error everytime?

That's correct SR!

Yeah, your are missing the Cut/Plot window. Try reinstalling into the following directory: C:\Program Files\Corel\CorelDRAW Graphics Suite X4\Plugins\

I had the same issue on my SP-300v, The problem when away after I replaced the Black & Cyan Damper.

Perhaps the rubber around the capping station is worn out, cracked or all gummed up or the print head it is "cattywampus", isn't fully flat (parallel) . Take the side cover off and look at the print head over the platen.

It could be the pump.

Where are you located?