Search results

Set the ip v4 in laptop ethernet to 172.17.15.100 and on the machine to 172.17.15.101 and configure flexi to print to this ip.

I guess that the SMD fuse on head board is blown up.

When purged, is ink dripping from affected slot? Could also be the printhead pcb. Try swapping it

The pump you hear near ink pumps is the double head pump for degassing vacuum. When you tap activate heater, does the button text change? Have you checked heater elements by touching both of them? If temperature doesn’t change system provide you an error, for sure. Let it heat for certain time...

AlsEU is right, one (or more) of the printheads providing wrong temperature values. But the temperature value shown in the GUI is just an visualization of the average of all temperature sensors together. This value is not used to activate or deactivate the heater system. The heating system is...

For better understanding, the color calibration (linearization) is based on the very first color reference done on the initial color calibration. This should be created with best performance of printheads and substrate advance. Sometimes this database gets corrupted resulting in color shift...

Left- and rightmost edge of the image is correctly aligned? Does it happen with all colors? The picture provided shows a solid containing cyan and magenta, and you can clearly see that all printheads stopping firing at exactly at same time. Maybe some linear encoder pulses are missed or there is...

On zund it’s spring loaded. Try with the through cut the flatnes of your table. Put a substrate onto table and set cutting deep to 0.1 mm so that it just scratches the surface. Move the knife over the whole table and check if it is everywhere similar. If not your table is misaligned

L08 if I’m not wrong is the heater, fuse or its triac.

Switch off the printer and crisscross the flat cables to the printheads and do a testprint to know if printhead or electronic is defective.

Your welcome. In addition, even if you have done a perfect alignment the cmyk droplets are different then w, because white pigments are titanoxyd. This makes the ink heavier and the droplets splatter more.

In spot color tool just reduce white one pixel

Little bit of voodoo in this chat. The only way to get a clue on the reason for your issue is to create the logs and post it.

Well explained, but in your explanation I miss the tracks to be added in between table and beam, to prevent from being wound. And the removal of air-letout of turbines, to give more space to the uneven floor. Also I would remove cleaning web to protect web wipe station in case. Securing the...

Could be also motor or electronic in the UM

Does it start to rotate during init? Prevent direct sunlight onto sensor. There is no specific position belt/sensor

Because in fact the ink is higher pigmented then in Gen3 you will need less ink to reach the same saturation. This will lead to less temperature to cure ink when running same productivity. With the 800w I can print on very heat-sensitive media, which was not possible before. White is really...

Between Z and Latex is a big difference, since the Z detects a broken bag inside the cartridge itself and latex only at the pip

What kind of ink u are using?

It’s an older Roland The cap tops are looking very used. The filter inside looks partially very swollen. I would suggest to replace them.