Search results

Look up flood fill ink level. Here is a link to the manual I think addresses this. https://www.manualslib.com/manual/1910068/Canon-Arizona-1300-Series.html?page=165#manual

I'm assuming you are using Onyx? The problem might be your white ink level. You can select 1-6 I think as your levels. When I run my 460GT at level 6 I see banding in white, when run on level 5 it is smooth. I think if you right click on your job, select edit printer setting then select your ink...

Canon is now reselling the Digitech in their lineup so you do probably have service in the area if you buy through Canon. I am impressed with Digitech as well based on discussions with them. Currently have an Arizona 460GT and an HP R1000 and both machines do well. The Arizona is a 2013 model...

Thank you. It turned out that my magenta head was dislodged perhaps from pushing too much during head vacuuming. When reseated alignment was good. Still interested in your procedure though.

Asphalt-Art/Alumagrip or Mactac Streetwrap if only a few months.

Also make sure all the heads are in place. Sometimes just vacuuming them or a media hit can dislodge. Push down on the heads after opening carriage cover. Also white ink can be adjusted to different level in the rip. Level 6 shows some banding level 5 is usually good.

Update on my 460GT. Moved it today about 10 miles. Hired a rigger to move it and they built a crate for it. I prepped the machine by locking the gantry with the original blocks, lowered the carriage onto the rubber bumpers from the original installation and drained the ink reservoirs. I also...

Thanks I had a crate built similar to oem that we'll use to load it and have the carriage bumper and gantry blocks. In place I'll drain the reservoir as well and remove the inks. It will be powered down for about 24 hours.

Hi, regarding moving your printer. Did you drain the ink reserviors above the heads or did they maintain negative pressure and not drain out?

The safety button on the console wasn't pressed? I have put paper on it and it stops operation.

I have an R1000 that the outfeed monitor side lost the touchscreen capability. I am suspecting it is the monitor and not the software. Does anyone have this experience? It's a 2018 model.

Thanks that is great info. All my heads are good just my magenta is slightly off and can see very slight magenta line on edge of some prints. I will message you if you can send the alignment software tool.

Do you have any more info on self-calibration? I have a 460 GT with 1 color just sightly out enough to be annoying. Can it be done without a service key?

Hi, did you have a tech come and do an alignment afterward?

On these forums we discuss equipment and processes all the time but spend little on best business practices. I found we were giving away so much free setup time for resubmitted files and easy touch ups that added up to at least an hour a day of billable time. That's $25k per year!!

I see where it allows me to enter percentages of the color but not a different CMYK breakdown.

Thanks for clarifying Nate1n22.

I am also reviewing the Trufire and have looked at Vanguard as well. Very impressed with Trufire. I love how people complain then never explain their issues.

Great Ill give that a shot.