Search results

Got roland SC540, bought used a few years ago. Does a great job, as I'm a small shop, not using every day, etc. My question is regarding the print modes. I had the Roland service here about 8-9 months ago for a tune-up, and all works well until lately. Whenever I get ready to print a job, the...

Got a Roland 540 XC, had sit idle for 2-3 weeks. Now, I try to print, can't get any yellow. Did several head cleanings, no dice. Replaced two plastic caps on the yellow head. Nothing. Seems like it's not "pumping up". Could it be a pump? If so, how big of a pain is that to swap out?

Having problems with printing on Arlon 4570 X-Scape. Using a Roland SC540, Media 1 ink, (eco Sol), and keep getting what appears to be slight lines across the printed area. Have cleaned the heads, (3 times), still no difference. Have tried a different number of Arlon, can't find a number on it...

Shut down the 540 the other night, all working well. Come in today, gonna switch power cords to new outlet, and after making sure all was good to go by professional electrician, plugged in and flipped the main power switch on back. Got a message , something to the effect of "Turn on power...

Was sorta thinking that was my problem. Using Rapid Tac, (and a bunch of it). Was not helping matters at all. Thanks for the advice!!

Folks, I'm sure this topic has been discussed at length before, but forgive me as I'm new on the forums. My question is: how is the best way to apply vinyl to glass? Seems like the majority of times, I simply have to "worry" the transfer tape off. I usually wet apply, with Rapid Tac, and I don't...

Greetings from Southern Indiana. Have had a CX24 cutter for about 12 years or so, and was pretty familiar with what I was doing with the cut-vinyl stuff, with Signlab 9.1 vinyl. Now, I recently got a Roland SC540EX to expand my graphics availabilities. Software is Signlab Print & Cut 9.1 ...

You were right. was set off as far as possible. prints/cuts perfect now. Thanks for the info!

Folks, I'm new to the forum, and have just got an SC540EX print/cut (refurbished). Having a problem with the thing not wanting to cut the same path as I tell it to. It acts as if the kerning is different for the cut than the print. Both will start at the same point, but by the time it gets 8"...