#cjv30

HELP!!! I had a head strike and as a last resort to get the nozzles i lost back i syringed cleaning solution through the print head. I have now recovered the nozzles that i initially lost, but i have now lost all nozzles on the adjoining black nozzle. Any suggestions would be greatly...

Recently my boss acquired a used Mimaki CJV30 and its accompanied RIP computer with RasterlinkPro 5SG. The computer also had Adobe Illustrator C5 and an older version of CorelDRAW. Coming from the world of Roland, for cutting I'm used to adding a cut line of the pseudo spot colour "CutContour"...

Recently had some issues with one side of our yellow nozzles not firing half of the test print, one side was good, the other only bottom half roughly was firing. Now we currently have no yellow coming out of either side. Have tried all the usual washes, ink fills, etc. several, several times...

after changing damper and flushing the head .the printer with no message of error .i have done INK FILL UP and run several test print .still no INK coming out ???

Hello guys, My CJV30-130 is used to print "rulers" in the width, so it has to be very precise. The problem is that these rules are good at the start on the right side, but some are shifted a bit and we are left with a difference of up to 5 mm more on the left side compared to the drawing...

hello every one I'm facing this problem on my cjv30 after trying to recover my genuine print-head. after reading so many comments the only solution could not try till today is 1- Downgrade firmware from 3.0 to 2.2 ( can't find 2.2 firmware on the net ) 2- boot machine on service mode and re...