mimaki jfx200

Printer was working fine on Friday when I left the shop, and when I came in Monday and started doing the normal print tests and cleaning in the morning noticed the entire section of yellow was missing in the test. I should note that I did recently change the main capsule filters about 2 weeks...

Has anyone had any experience with switching out their clear tanks for mimaki's printable primer? We've had our printer for about a year and the currant setup is a CYMK 2x clear 2x white and we almost never use clear for anything and are really just dumping money down the drain with it at this...

It's getting about time for our JFX200 to need it's primary capsule filters replaced and the official filters are 10 microns, we happen to have another filter in the shop that is nearly identical except its a 5 micron filter so the question is has anyone every tried using a 5 micron filter...

Back with round 2 of printer gremlins, this time it is the white and clear subtank draining all the ink when the machine goes into sleep mode usually a minuet or so after the cycle ends. The color subtanks seems to be unaffected and stay filled. I have run an air purge and ran the negative and...

Greetings folks, I work for a small company that recently picked up a Mimaki JFX200 second hand and while it prints pretty well most of the time there have been a couple quirks that have come up. we will randomly have the one or two of the color channels just not print (typically black and...

Our JFX200-2513 flatbed printer stopped working originally with a HDC error. We replaced the HDC board with a G5HDC board without much luck. We now have this error: ERROR 12e HeadFaild /HDC[1 ]. The board and heads do no show any shorts between COM and ground. Any ideas??

We have two fairly new mimaki jfx200 2531 and run rasterlink 6 on both and all of the sudden one of them is not printing a gradient the correct or normal way. I have attached images and seeking some help. Bear in ming these are the exact same files and both printers are ran with independent...

Does anyone have any information or experience knowing the longevity of JFX200-2513 prints on substrates like Aluminum with a baked enamel finish, Coroplast, etc? I'm having a hard time finding anyone who can tell me how long my signs will last outdoors, and that's pretty much the most common...

Machine streaking on right side and left as it starts print. See photos. Anyone else experience this?

I have a mimaki JFX200 printer. I have some dried ink buildup on the lenses for the UV lights. I was wondering if anyone out there has any idea on how to clean these, how to take them out for cleaning or even what they are made out of. Thank you!