motor

Have a Mimaki CG 160FXII cutter, from 2013. Just started making clanking noise when doing horizontal cuts, and on rounded corner rectangles it cuts opposite corners at an angle instead of rounded. Not sure if belt issue or motor issue, no idea honestly.

I'm a newbie to this machine and had it working for a short while. Recently, when turning on the machine I got the above error. I also have an illuminated Red LED for AMP FAULT. All the green LEDs are lit apart from SPIN #2 My background is in embedded systems (mix of electronics and software)...

Hi Guys I have been signwriting cars, vans, trucks and trailers for over 6 years now. I have built up quite a collection of decals and stripes but was wondering if there is a CD out there for side stripes and campervan decals that any of you would recommend, I know that on Ebay and such places...

Motor is stuck and won't budge. Message Says "motor error turn off power". In the past I was able to manually slide the motor casing back to position. Is ther a release button? It's a dinosaur, Roland fj-50

Hi, does anyone have any experience of oiling the y-axis motor on the Mimaki JV33-130 - ours has got quite noisy but wondered whether oiling rather than replacing would or could be an option

Hi Our JV33 has become very noisy over the past 2 weeks when the head carriage goes back and forth. I have spoken to an engineer who gave me a price for a new motor, but thought I'd check with other JV33 users before I spend a bunch more money on it. I just spent over $2.5k on a new head after...

Have just R&R'd 3 pump motors and have a 4th ready to install for the wiper scraper. However, it is mid way into the chassis, and from observation, not easily accessible. It appears I may have to remove other components to get to it, just not sure on where to start and how difficult this is to...

Has anyone had one replaced yet? I had one fail on me a few weeks ago and HP replaced it. Now the new one is starting to show the same symptoms. After each carriage pass, the spindle advance has a nasty little 'click' to it that gets bad and then stops and keeps randomly doing that...

Hello, i'm getting on my mimaki JV33-160 error 250 y coordinate and i want to raplace the y motor i found a site selling this from china for $249 it does not look exact the same i would like to know if this is the right part. here is the link...

This is my sons dirt bike. I wrapped it for him.