• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

origin

  1. Need Help CJV150 have to set Print & Cut origin adjust every job

    Hi all, Got a CJV150 we've had for about 3 months and every time I do a Print & Cut job the X origin seems to be out. Y doesn't seem to vary. I've run the P&C Origin Adjust several times and often have to re-run it after the next job I send cuts out of the print... I'm only setting the 720dpi...

  2. Mimaki JF 1631 origin issue

    I have a JF 1631 flatbed and I printed a table and then went to print another table and the origin shifted back on me about a 1/4 inch. I have shut it down and restarted a few time, slid the gantry to different positions, unplugged the machine for a bit and every time I try to set the origin...

  3. Mimaki JF 1631 Origin Issue

    I have 3 - jf1631 machines but one of them is having an issue I can't figure out. The origin is being inconsistent left to right. So when I am standing at the control panel, in the nearest right hand corner the origin right there is moving around on me. I can do a print and then the next...

  4. Graphtec origin?

    HI Folks, I have a question for y'all regarding the "origin" as it relates to the Graphtec. I am currently using the FC8000-130. I'm cutting sandblast resist. Before I cut the resist, I like to run the plotter with the pen over the design to make sure the design is what I want before cutting...
Top