Caldera Help

[Stella_FB700]

Trying to print a spot color of white in caldera V9
File is set up as a PDF with "spot color -white" CMYK
Its printing a full flood of white and not the shapes created.

Any help would be appreciated.

 

[ColoPrinthead]

Their is an option to specify what white you want, spot, underflood, and over flood. IIRC it's under one of the tabs from you image window/panel.

 

[ColoPrinthead]

Page 11
http://support.caldera.fr/downloads/DOC/en/GrandWhite.pdf

 

[Stella_FB700]

Their is an option to specify what white you want, spot, underflood, and over flood. IIRC it's under one of the tabs from you image window/panel.

I have everything set up - please see picture. Just for some reason its printing solid and not the actual shapes.

 

[Stella_FB700]

Page 11
http://support.caldera.fr/downloads/DOC/en/GrandWhite.pdf

No such luck, any suggestions?

 

[ColoPrinthead]

I would call their support line and have one of their people log onto your RIP and take a look. I don't know if they have a number for Canada but in the US it is 612-216-5212

 

[Stella_FB700]

I would call their support line and have one of their people log onto your RIP and take a look. I don't know if they have a number for Canada but in the US it is 612-216-5212

Thanks for your help - figured it out after just playing with it. Tech support - terrible for us Canadians.

 

[ProColorGraphics]

I have never had that issue and curious as to what the problem is? Also, I don't think V9 is supported any longer either if I remember right.

 

[Stella_FB700]

I have never had that issue and curious as to what the problem is? Also, I don't think V9 is supported any longer either if I remember right.

Turns out i have V10 - didn't think i upgraded.
But the issue was basically using the white mode i needed to use the print mode "photo" and nothing else.
Everything else registered into the system.
"Had a idiot moment - just had to play with the settings - haha"