• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Feed Comp Problem?

P

printexpression

New Member
I have a JV33-160 and last week I printed 4 joining panels (as separate files) and for some reason the middle 2 panels were sqashed 10mm shorter. I was told to clean the rollers and heater bars, which I did and have been doing so since (I even use silicone spray to keep it extra smooth).
This week I printed a 9 panel wallpaper and used my Rasterlink software to tile. When the installer tried to get the job done none of the panels matched up and we have run at a huge loss.
Can anyboyd help me with this problem? I'm desperate for answers so I can reprint the wallpaper with peace of mind.
 
A

anapurna

New Member
it is most likely a rasterlink setup rather than hardware malfunction. double check your tiling settings. are you checking the overlapping option? did you print the overlapping marks?
 
You must log in or register to reply here.
Top