I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
We are trying to send 100 decals that are pre-spaced letters through cutting master 2. Cutting master 2 says "Cutting 0%" and nothing happens. Any ideas?
Talked to Graphtec...
...He told me that since I offset the cut path I just need to reprint he whole job and scrap what we printed??! This sounds ridiculou to me. Other cutters I have had, had no problem going over the same cut path. Plus, even though I offset the paths, the decal and the...
When I first started doing print and cut files through Onyx Cut Server, the registration on my cuts was an absolute nightmare. all the test would always check out, but some days the darn thing just would refuse to cut in the right spot, not to mention the registration mark sensing issues. After...
So we wrapped the back of a toy hauler. The edges of the area had a latex sealant applied. Obviously, our graphic isn't sticking well where it was laid over the sealer. The customer does not want to trim the the graphic back a 1/4" if we don't have to. I am thinking we should apply another latex...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.