Recent content by dstees

Don't even ask. One of those "friend" deals.

I have a customer that makes number plates for gokarts and motorcycles. Currently, the way it is made is a clear piece of lexan with vinyl numbers reverse cut and applied to the lexan. i then put a protective layer over the numbers. This way, when you look at the plate from the front you see...

i'll start with 1 set (7 decals). It will probably need to be tweaked. Once that is done and quality is acceptable, we're looking at probably 10 sets to start. I would say the demand is around 30-40 sets total. Could be a little higher.

who would be a good company to talk to that could do this for me? decals are roughly 10x23". Contour cut, outdoor use. Small orders most likely. thanks for help!

I am new to digital printing. I need to be able to make OEM quality decals for outboard motor cowlings. I have a roland gx-300 cutter. I need to be able to print up to 11" wide, so a 12" printer would be perfect. Hopefully, i would be able to do contour cuts on the roland. Anybody have any...

I'm looking for a few 15" x 1.5" round HDU foam sign blanks. Anybody know where i can get them? thanks!

Bethune.

Honestly, I didnt have the number written down, but that is beside the point now. But, I'm sure the number is in the system, just havnt called to check it.

Good News! A fine young man by the name of Jesse Garcia @ Roland just gave me a call and he is sending out a replacement cutter today to use while they are fixing my cutter. Thanks Jesse! I have been a longtime Roland user and I knew that you guys would make it right. Sometimes it just takes...

This is the same line I got from Splash of color. The cutter and USB cable are not in a traffic area. And I personally dont care if its not common. Also, the first time it was fixed the main board was replaced. This time it is just the USB port. The place i sent the machine obviously doesnt...

This is a forum, right? I have talked to Roland directly. I am simply trying to get a little feedback as to what I should do in my situation. I see you are a Roland dealer.....thanks for the advice!

Ok, so I contacted Roland after this post and they let me know that my main board was good, but the USB port was bad, (changed their story). they gave me 2 options: Option 1 - They said I could use my serial port and the unit would work just fine. They would inspect it to make sure it would...

I have a GX300. Last year about this time my main board went out. the cutter would not communicate with the computer. A couple weeks ago, it happened again. I talked to roland this morning and they said that they arnt going to cover it because they just fixed it last year. What a bunch of...

maroon and black are the colors the company has used since day 1. i cant change that. i am going to use trans. vinyl on white acrylic. thanks for all the help!

what should i do with the seam in the black?