I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Only one of the panels has the logo in it.
I think I will do the 1 inch al the way around, generally I tell the customer I will return a few hours after I have installed the etched vinyl and remove the masking and trim the edges.
I will most likely just use rapid tac squeegee the corners in and...
Good Morning all,
I am about to do an installation where the etched vinyl goes right to the edge of the windows. The windows are on an office front inside a building and they are recessed about a half an inch into the wood frame. I have had trouble in the past, I was successfull but it was...
Thanks Craig, that was the response I was insearch of.
Appreciate it.
It is a complicated situation as far as process that needs to be taken in this particular case, not worth wasting the time trying to explain it but I definitely agree in most if not all cases a new substrate is the way to go...
Unfortunately, for this particular job do the the size and nature we were unable to order new acrylic.
We will be removing this existing graphics and doing it that way.
Just wondering if anyone has used either of these two tools to remove graphics and the benefits of either using one or the...
Hey Guys,
Noticed a couple of you have mentioned using a hot water pressure washer, or steam wallpaper remover for graphics. I have a large acryic sign that needs to have the graphics removed. They are extreamly old and I was wondering if you would reccommend usining either of these to help...
I run a Roland VS-540 (eco-solve ink). Most of the design is black and why we are contemplating how we will put it together. Cut vinyl is an option
2 to 6 years is within the timeframe I gave them as far as fading.
I appreciate the quick replies
The customer understands about fading, but what would you consider to be (no time at all)
The top of the sign is only about 20 feet in the air so it is not as high as you would think.
JF.
Good Afternoon,
I 10'W x 8'H backlit sign that a customer wants redone. There design is full colour and covers the entire sign face. My question is if I panel it, when it is backlit will the overlapping seem show through?
If so how would I go about paneling such a sign without that...
Hey Guys,
I use CS3 and VersaWorks on a Roland545. WHen i place a gradiant in something as large as a tradeshow booth the transitions in the colours show up distinctly on the print. Its almost as if there is distinct lines across the prints showing where the gradiant transitions from colour...
How do you go about desging window perf on the back of a car/van, that is curved to look straight?? is there a way to measure the curve so when you apply it it gives the appearence of straight.
Thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.