I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Thank you. I will definitely take your advice. Are there any tutorials or instructions or advice for that procedure of replacing the dampers for the VS? Is there anything else that would be sold separately? Thanks!
I need some help from anyone who has perhaps been through this issue. We can't print yellow without black specs showing up. I've included pictures. We just replaced the following, the capping station, felt, wiper, and wiper scrapper. We've performed multiple manual and auto cleanings. We've...
We removed the encoder strip and cleaned. It still is laying yellow down on certain prints. I contacted a couple Roland tech centers and they say it's the ribbon cables and that they need to be reset. I checked them and they look good. They also think that the cables could be overlapping the...
Anybody out there with any tech experience have an idea what could cause this. I contacted my local tech dealer, and they said it usually would be $300 for a service call, but would only charge me $200, then it would be $140 per hour for labor. They said they think it might be some wires that...
We just recently replaced the scan motor on our 2 1/2 year old VS-540. We updated the versaworks software as well as the Roland printer firmware at the same time. Ever since, on occasion it'll print yellow bloches about 1 1/2 to 3 inches from the right side. It's not on every file or print but...
Ended up being a defect with the packing grease getting on the tension disks. Drytac knew about the problem and the techs came out and installed a new set of teflon tension disks, and it works like it should now.
We've been using the vs-540 for a year now, and we switched it to only pass what it's printing. It hasn't caused us any issues that we know of. It's a lot quicker when it doesn't have to pass all the way across each time. I forgot if the setting is on the machine or in Versaworks.
I'm intersted in this as well.. what material... who to purchase from... we currently sub out our flags and would like to know what the Rolands are capable of printing on textile material. How long does the ink last on fabric and what people are doing for hardware..... thanks.
I posted earlier about the issues we're experiencing with our laminator.
If I'm laminating something and have 'hand tight' tension on the take-up reel tension knob, if I grab the roll while it's moving, should it stop with very little pressure, or should it be more difficult the harder the...
I need some advice on setting up and running a 55" Drytac cold laminator.
We have no problem with webbing the laminate, but for some reason when we're runnning material, the point where the backing separates from the laminate, gets 'sucked' under the rollers, along with the print, as we're...
Everyone talking PC is great, but what OS? It matters when considering maxing out your RAM. XP-32, XP-64, 7-64.... just curious when you're putting together a PC what OS you're deciding on using. Thanks.
We just purchased a backup dell desktop with windows xp 64. The problem so far is that it won't load our flexisign 8.1 properly. It keeps saying that we're missing a file when we've loaded the same software to other xp desktops without issues mulitple times. Any help would be great. Send me a...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.