Search results

Graphtec FC8600 Easy to set up and user friendly. Only consumable is blades.

It looks like some clogged jets. Do a few head soaks and make sure your caps are in good shape, not warped or swollen. Also check and clean your cables. Could be an electrical issue.

I use to screen print invitations, coasters and promotional pieces in the 90's on clear acrylics. I would reverse the photo or artwork of the image then flood print over it with white or silver ink. So if you have access to a screen printer you can flood over the image.

Just manually slide the carriage all the way to the left then another 1/4" and that will disengage the cross cut blade.

I do remember that set up feature now. I hope this helps Tyler322. Thank you for sharing.

Check the Send Mode. Located in the middle of the Materisl setup page

Try a different percentage of window perf. One with smaller holes

I ran across this same problem a few weeks ago. I now make sure the design I send to print is finished loading, ripping and ready to print before I send the next design. It only takes a little bit of extra time to process all the designs for an order and by doing this I can send multiple designs...

I had this same exact problem 20 years ago. It turned out it was me. As I am not a graphic artist I am a printer. To correct the problem I hired a graphic artist that knows all the designing programs like photoshop, illustrator, quark expres coral draw and indesign. They created the the project...

Or Cut reg marks off an old job and stick over the silver glitter ones

I do your option #1, #2 and #3 on my graphtec 8600-130 and 8600-160 all day every day from sizes 2x3 oval to 12x24 rectangle and ocasionally some 24x36 ovals. Haven't used the perf cut in two years. Once you know how to operate and set up your cutter you can Die Cut or Kiss Cut any shape. My...

Have you tried raising or lowering your head height?

Now it sounds like your material isn't laying flat against the cutting strip or your blade is too far out. If this continues make the call Phil Johnson Airmark Corporation (800)527-7778, ext 112

YOU WIN

Just smile and redo the job at no charge. But when he comes to pick it up ask him for the first set back so that you can put it back in Inventory and when he says WTF you smile and say gotcha. You will make a new friend and a life time customer that will refer you to all his boat buddy's.

I just finished printing eight rolls of Flex Mag 30.5"×50' roll to take up roll on my Roland Eco Sol XR-640 . No problems at all. Each roll yielded 600 + individual magnets sized at 5.1"×3.5". 22 designs at 28 each. Solvent ink dries to the touch pretty quick and dry enough to cut within a...

I'm grabbing at Straws now. My problem was resolved when I replaced the ribbon cable

Sounds like there not communicating fully. Try Reinstalling Onyx

Call for a warranty repair

The ribbon cable that drives the head.