Search results

Glad it worked for you!

Glad you got it running!

Remove power plug ,- turn on to discharge remaining power. turn off. Remove left and right side panels- reseat ribbon cables for from panel- there are two. Re-seat all Pxxx Connectors. Check all connections on the right side of power supply Check power cord - sometimes they don't sit properly...

Plotter sold.

I dont recall that- but a pair of nice Revlon tweezers grab those little buggers in about one or two pieces :)

Power supply -removed 200.00 CPU board - removed and in Electronics Bag - 200.00 2 Axis Board - removed and in Electronics Bag - 200.00 Misc. wiring harneses and front panel removed. Pictures available upon request. Shipping to lower 48 - 24.00

Selling my Gerber GS750 Plus Plotter. Unit cuts great- no errors in operation. Drum in very good condition. No deep scratches or gouges. some light scratches. Small Crack on right wheel- doesn't effect performance. Price 3,300.00 The Gerber GS750 Plus is known in the monument industry for...

check your plotter - I had the same one - and make sure commands settings for pressure, speed pen etc. is on the plotter itself, not taken from the computer. I cant recall the command menu location.

Price Drop - 2,000.00 plus shipping ( hard case deposit included).

This software is sold.

Selling my Gerber Edge 2 Printer. 2,000.00. Shipping 320.00 ( includes hard case deposit and return label) Machine prints great. A few notes: 1. Condition- good - very clean. 2. Print test- good- no bad pixels. Registration for multi color- good - see picture. 3. Good Shocks. 4, Vinyl...

Selling a copy of Omega 2.1 CP - comes with installation disc, profile CD, Dongle and short Manual. I tested and operated software and dongle - it is in good working condition. 495.00 UPS Express shipping and Signature required. I called Gerber Service May 24- and this Serial Number dongle is...

Yes- you can try the reset- but I would write down all settings before ( but you cant see them). For the LE - with unit off- hold reset / turn on while holding- keep holding until you see OFFLINE on the display. If reset doesn't work. At 1:09 in your video- there is a block with five screws-...

I re-read your first post- it said you saw this printer working - I assume you saw it print... I am betting its a loose connection - the P872 is a labeled connector on the top circuit board - try that. If you are unsure about checking voltages- then I would not attempt.you may hurt yourself or...

The lower chassis fan shares the same area, "block" (TB2) as does the control boards (wires to Upper board first). On TB2 at power supply, #4 and 5 run the lower Fan at 12V . #4 and #3 - Orange and Black --go to the 2 axis control board P872 harness. so check for power at that point - where...

Good point - not sure on that one

Hello, I saw your you tube videos- Does the chassis fan stay on when you power up? If so, i think something is wrong with either the P872 cable or upper control board. I would 1. re-check all connectors on the boards. 2. Check / replace fuses in power switch 3. Check / replace Fuse F1 on upper...

Gerber makes a certified USB-Parralel cable - P83301A I had problems when I used a generic sometimes on flexi. no experience with signlab.

And your port should be setup for ECP communication in the software - most likely

Hello, I just bought a system, and I believe it is coming with 2.0 or 2.6. I will have more information by Tuesday or Wednesday. ( I already have 6.5).