Search results

I would like to see just one photo of a liner on acrylic or polycarbonate blistered from outgassing. Just one. No one ever saw one sheet with a blistered liner that I know of. Has any one ever observed a single photo with a liner filled with bubbles? In all the decades has not one photo been...

set the rollers as wide as possible,, the home the plotter

The corner peeling sure looks like somebody pulled on it..

That is a huge load of water under there. I do not believe it is water in the least. The volume of the blisters is way to high to be water or soap or alcohol.. Personally. I never ever had pickled skin after learning how to correctly apply vinyl apply to polycarbonate or acrylic. Also...

No one miserable here. You made a mistake. You have to deal with it. Just as all of us have dealt with the same problems at one time or another. You got an entire lifetime of advice. But you did not get affirmation over your theory that it was outgassing. Simply because outgassing is 98% a myth...

those blisters have nothing to do with "outgassing". There is way too any blisters with too much volume to be outgassing. Outgassing is a myth. Some will always blame outgassing for blisters on plastic. The only way to avoid blisters on plastic is to either do it right with a properly...

is it spring yet?

yup, you got borked. No deposit always results in a borking. He is a thief. Get the bus back to the shop.. acting like you will install more decals and then,, peel all the graphics. Then call him to retrieve his bus. Do not drive it again. You will be blamed for some unknown fault.

I wish I had a photo of a trailer wrap. It was low balled beyond all reason. The low ball was so low the client asked me why I thought my work was so much better when the other guy could do it for about 1/4 of what my bid was. It was parked out front of a business for a few days looking ok...

I've become disgusted with the whole " it's cheaper" mindset. The entire walmart mentality is taking over. Just the other day a lady bought a service discounted to $159.00 after spending about half hour indirectly asking for a discount. She went down the road and found it $5.00 cheaper...

stuf that small? Exacto knife, ruler and a french curve. That is what I used years ago. Worked just fine for the occasional once a week small jobs. It takes longer to lay out the job then set up the cutter using a machine.

many codes do not allow stuff on the outside.. Better check.

Never use fakes. Never,, Nope never ever., They will clog the heads guaranteed. As for production?? I use them for all kinds of production work. Run them all day sometimes. They rated for that. The old 860's? i had three of them and ran them into the ground. The ink at $5 a block was so...

the ink for this is on the high side. This phaser has trouble with 19 error codes. Dead heads. or a dead power system. I would not keep a big inventory of supplies with it. It could last a decade but it could last just a little while. I have a dead 8560 here. It ran great until it did what...

what is PS vinyl?

norton, avg and mcafee are known headache machines. Cause all types of interference.

that clockwork site used a friggin popup signup deal.. I hate it when trying to look at a page only to get blasted with some crappy popup nag. I hate it when I have to sign up to see something. Then touch a graphic and a blocker screen slides in and covers it all up.. Useless forplay. I...

ya, at that price i think very few will have to worry about it

have to do a 3d clean up pass using an offset. And when making your art you could use a higher resolution. Set the pass one half the distance to the center line of the BALL end mill. Aspire measure BALL end mills from the centerline.

Perfect idea.. and it is cheaper than a land line as well. Free hand set plus a half price extra line.