Search results

Depends on the vinyl. If you are using high performance vinyl to cut and apply, then wet is very appropriate in many circumstances. I have "wrapped" large areas of vehicle surfaces with 2 mil high performance intended for cut vinyl lettering, and the only way is to float it on. You might try it...

Yeah, Gino, sounds like it wasnt digital media with any air release. Bob, it could be as simple as starting at the front and working back instead of the other way around. The tendancy would be, of course. Way back, a bodyshop had me come in and install replacement hood stripes on a Mustang GT...

Welcome to the show!

Welcome to the show!

Next time you make a pound of bacon, throw it in a plastic bag and douse it with about a half cup of liquid smoke first. You might change your mind!

I was using some liquid smoke in a recipe, and i occurred to me to ask - just where does liquid smoke come from? As far as I have observed, there is no juice leaking out of the fireplace....

Acquiring sign substrates on an as needed basis may be a challenge in the WY area. There's 45 miles of nothing between towns, and not many towns. I'll bet plywood, not MDO, is the panel being asked about here. I would invest in a pallet of alumacorr or something.

For interior or exterior application? I'd be leary too if for exterior.

Oh wow, good luck! It will be good for you to be able spend time with him!

OK, I guess I can wing it. I had taken one apart some time ago and took a photo of the background image. I can print that, sandwich it between board and acrylic, and put cut vinyl on top, and I'll use printable brushed alum film from R tape for the silver plate. Close enough. Oh, and the local...

Start>run> Pretty cool, thanks Neal !

Before I go the trouble of making these up "peice meal", I thought I would ask if anyone recognizes this Audi technician's plaque. Is there a vendor out there where I can order it as a kit and then just insert my printed background image? It is 18"x24", maybe 1/2 inch MDO for the print board...

:goodpost:

do you have the fixes downloaded from SAI ? I believe there were some updates for 7.5

How long will it be offline?

if it's fresh paint, prepsol (wax and grease remover)should do the job. may take a little soak and a little rubbing, but it wont effect the acrylic

Welcome to the show!

Georgia

PS - my suggestion - Pre and Post heat

J/k