Search results

Good Morning all, I am about to do an installation where the etched vinyl goes right to the edge of the windows. The windows are on an office front inside a building and they are recessed about a half an inch into the wood frame. I have had trouble in the past, I was successfull but it was...

Hey Guys, Noticed a couple of you have mentioned using a hot water pressure washer, or steam wallpaper remover for graphics. I have a large acryic sign that needs to have the graphics removed. They are extreamly old and I was wondering if you would reccommend usining either of these to help...

Good Afternoon, I 10'W x 8'H backlit sign that a customer wants redone. There design is full colour and covers the entire sign face. My question is if I panel it, when it is backlit will the overlapping seem show through? If so how would I go about paneling such a sign without that...

Anyone have the Service Manual for the Roland VS - 540? Let me know Thanks for your time. JF.

Hey Guys, I use CS3 and VersaWorks on a Roland545. WHen i place a gradiant in something as large as a tradeshow booth the transitions in the colours show up distinctly on the print. Its almost as if there is distinct lines across the prints showing where the gradiant transitions from colour...

How do you go about desging window perf on the back of a car/van, that is curved to look straight?? is there a way to measure the curve so when you apply it it gives the appearence of straight. Thanks

Anyone have the Service Manual for this machinge "Roland 545 SolJet PRO II V" Seem to be having every problem in the book. Thanks

Hello again, We have been having some major issues hahahaha, We are getting a verticle banding on all of our prints, doesnt matter the profile, the material. Weve changed the printer calibration, print feed calibration. Seems like weve tryed everything. Well hopefully not everything...

Hello, I am running a Roland SolJet 545 with ecosolvant inks and we pulled out a light cyan ink cartridge to find that the end had been melted. has anyone ever had this issue. Any insight would be appriciate, solution cause, anything!!! Thanks guys Attached is a picture.

I have attached pictures of the following issue. We run on a 54" Roland 545 SolJet, and use ecosolvent inks. We are expierencing the issue in darker blues and blacks. Its a light band that randomly runs across the entire print. It is always about the same width in size (1"). We have...

We have a roland 545 and are having problems getting our printer to register all of the alignment marks before finishing a print cut process. Now we have tried adjusting the print making sure it is straight ext ext. Has anyone every had an issue like that, and do you have any other...

Hello, Just wondering if anyone had any insite on the best vehicle grahic training courses across Canada and the United States. I have completed a couple full wraps and from design to installation, but i want to further my knowledge in the area. Does anyone have any suggestions for the...

Just wondering about the Lastest technology in Vehicle Graphic Design Software... Any insite welcome. Thanks.

Hello, We are using the best possible double sided tape available to us, and we cant seem to get the headers and kickers to remain adheared to the panels. They come off after a couple days everytime. Do you have any suggestions. Thank you have a great holiday

Hello, We are having a hard time getting our printer to print decent solid colours. Everything seems to be coming out a very grainy colour. We have our heat generally set somewhere up around 40 degrees, it verys slightly between profiles. Generally it is MPI 3000 we are having the issue...