• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Search results

  1. accuracy of the S160T

    We just bought a new S120T and love it!! We were using a D160 before. We printed and lamed a 9' set of graphics and cut it on the 120t, removed it from the cutter, and then noticed that we did not have the blade set deep enough ;( We put it back in the S120T, let the OPOSX do its magic...
  3.

    Critique My Boat Name

    :rock-n-roll:
  4.

    Would you like some dessert with that sign?

    Have you tried the flame treatment described for Plasticade? Do a search on "Plasticade" and "flame" and there are several sites with the instructions in a pdf. Remember it is the flame plasma that modifies the plastic surface not the heat. I have bonded polyethylene to steel with...
  5.

    Would you like some dessert with that sign?

    A heat gun will not have the same effect as a torch. The frame oxidizes the surface and lowers the surface energy of the material so it is easier to adhere to. The flame method is how they treat some polyethylene materials to accept printing, otherwise the ink will not stick. A plasma arc can...

  6. Need a plotter?

    We have a SummaCut D160 SE we are ready to sell. It is a little bigger than you are looking for at 63" but it is a real workhorse! It has the OPOS sensor on it for contour cutting. It can sometime be a little finicky on glossy laminated material but usually with a light scuff and you are good...

  7. Help on 3M IJ-180C Onyx 10 profile for L25500

    I have made some headway..... I printed and read in a new calibration for the 16 pass mode. The blacks look blacker now and i do not see the banding. I will have to wait until tomorrow to put it in the sun.. That is where it showed the most. I still might play with the ink limits on the black...

  8. Help on 3M IJ-180C Onyx 10 profile for L25500

    Hi all, We are on our first roll of 3M IJ180C-V3 with our new HP L25500 ( thanks BigFish ) ans are having a little trouble sorting the media out. We are using Onyx PosterShop 10 for the RIP and the standard IJ-180c profile that comes with it. First we were getting some 'oily prints' on the...

  9. HP L25500 "Replace Faulty Ink Cartridge"

    We had that problem when setting up our new L25500. I was about to call our vendor for a replacement cartridge when on the 8th or 9th re-insertion it worked. I would pull it out and shake it a bit and re-insert. It might take several times. HP also has instructions for cleaning the cartridge...
  10.

    Opinons on our logo

    +1

  11. Goldrush Alaska

    +1
Top