Search results

Thank you,

Thank you, although they could be in yards.. o and some people use meters as a measurement for banners so...

Hi Gino, Sorry, I don't really get what your trying to say? Please can someone specify which measurements they are refering to when stating 3x6. I was obviously thinking about banners on shop walls, on trade stools etc so feet would be appropriate for these. Thanks,

bumpp

Many thanks for all the replies and apologies for the late reply. A few comments regarding the 3x6 and 2x6 - First question is are you referring to the measurement of feet? I ask this as I am looking to sell products on behave of vinyl wrappers like yourselves. Prices will be available for the...

Hi all, Just a simple question please, what would you say is the most used size / most popular for a vinyl banner? Many thanks, Kind regards, Ryan,

thanks,do you have a link by any chance?

i've start wrapping using Hexis HX20000 and pretty impressed with it.

thanks, just signed up so got to wait for it to be authorised.

Hi all, I'm after knifeless tape (the one that can curve round corners as well as on the straights) but in the U.K and finding in impossible. There's so many around in the U.S but that's no good to me. So any suppliers in the U.K who provide this would be much appreciated! Thanks,

What is this knife edge thing your referring too out of interest?

Thanks all for the replies. It's of a rear window and the rubber doesnt lift up as I did try that.

thanks all

Hi all, I was trying a few test cuts on the test vehicle and inparticular looking at how we would deal with cutting a straight line on the vinyl wrap under the seal to the vehicle side windows. I was hoping to knife would simply run in the gap but it seems to keep jumping out and giving an...

Thanks, so I guess after completing the little relief cuts, stretch the vinyl over the edge of the corner with heat and then pressure against the underside of the part. I guess this should result in a clean finish with no 'fingers' as pictured. Cheers,

Thanks for the reply, much appreciated.

Thank you all for your replies. I think I'll go ahead with the 2 relief cuts either side as stated. I wouldnt want to remove the wing as I would look to go into this into the future and that wouldnt be done on customers vehicles. Many thanks, Kind regards, Ryan,

Hi, thanks for the reply. The spec stated 80-90 degree C so this should be fine regarding the paint? Thanks,

Hi, thanks for the reply. Sorry but what do you mean? The only other thing I can think of is apply the graphics over the edge and then push the vinyl down and around the edge (as pictured) with a squeegee and then to cut. Sorry if that doesn't make sense. thanks,

Hi all, this question doesnt just refer to the edge of the wing but to the edge of many parts on a vehicle. The question is how would you wrap the part of the wing of a vehicle. I know other parts like the lower edge of the door you can just cut right up against the door eliminating this...