blades

Hello folks, As the title say I want to buy 60 Degree Carbide Blades compatible with Roland Vinyl Cutter and found this one on the aliexpress - https://aliexpress.com/e/_DFIL2vj Price seems good but I am not sure about qulatiy, any help is wellcome. Thanks!

I'm having a hard time getting vinyl over to transfer paper. I use transparent plastic transfer paper. My cutter is set to minimal presser when cutting but i still have a hard time getting it over to transfer paper. I was thinking would it make any difference if i changed the cutting blade...

I'm just wondering if anyone is using a zund and what blades everyone is using for different materials, foamex, card, paper, banner, etc. the main blades we use are a standard type 6 and a z17 but theres lots we have not tried. is there any better ones we should have? thanks in advance

UV Ink, the Driver for Innovation Innovations in the finishing industry came about after technological advances were made in the printing process that made printing on many substrates not only feasible but economical. This technology was UV printing—these inks are high quality and high fidelity...

Have found a couple great places for router bits that do not cost $200/bit like the summa ones do but I haven't found anywhere to buy the replacement blades like the heavy duty knife etc... Any suggestions? We have a Summa F1612 Thank you! AL

Would anyone know where to get the cutting blades for a mutoh ultima SC-1400D? They have the small stop on the end that a lot of them do not have. We are needing the 60 degree blades for the thick material that we cut. I can always find them on Ebay but they are out of the US. I used to have a...

Hello, Is there a blade that can cut through papers and not vinyl? It seems on 45 degree and foil blades it does not penetrate on the back of the paper.

Hi all! Just wanted to get some feedback on what what blade/settings people were using when cutting perforated vinyl on their plotters. I will be doing a job that will require a lot of plotting on 3M dual color perforated vinyl and I have never run it through my plotter (mimaki cg160-fx)...

Hello its me again, I've seemed to fix most of my problems with my mimaki jv3 160 sp. still having a problem with all the heads not being aligned. but my boss doesn't want to do anything about it. (btw all I had to do was replace the pumps. and the ink flow came back, what a headache.) Anyways...

I'm hoping the community here can weigh in on this for me as I keep getting different answers from different places. Originally, we were using a 45 degree blade on our Roland Sp-540V. But as our small lettering kept tearing, someone recommended switching to a 60 degree blade for fine detail...

So I have a few plotters one mimaki which I love to contour cut . One Chinese plotter (work horse) which uses generic blades. And a graphtec which I use too for do and ends . Ok here's the dilemma. Is there a after market blade holder for the mimaki and graphtec so I can standardize my blades. I...

I have a Master Plotter XY300P. Been using it for quite a while, (bought it way back) on and off. I finally need blades. Does anyone know what brand is compatible with this plotter? Where is a good source for blades?