cutting issues

Hello everybody I own a Summa S 120 T cutter and i'm facing a problem after i had to unscrew and lift up the tangential clamp (loosing 4 scews see pict) to remove a tangential blade wich was blocked alone. After mounting up everything the cutting is not horrible in sawtooth. Can anyone know...

Hello All, I'm experiencing cutting issues in one specific approx. 6inch long area (range), that can be seen highlighted in GIF below. Outside of the highlighted range printer cuts excellent, within the marked range it does not cut all. Also I've noticed if I'm setting the base point and I am...

I have been having this issue for 7 months since this printer\cutter was delivered and setup from Montroy. Flexi has downgraded the program to 12, reinstall 19, that is it. They like to imply I am the first person to have this issue. Montroy insults me by asking if the blade is in the right...

I printed some decals that were 22" x 6" inches. I used 54" roll. I put 2 rows of 8 (so 16 total decals). I had a small bleed so I just made a box around them to cut. The print was beautiful. The cut was not only off, it was way off. There first decal was kind of close. The next was about .25"...

Just recently I have started to have an issue with my Mutoh VC-1300 plotter cutter. The cutting is very poor, almost jittery, and is nearly impossible to weed. I can even run it through a second time and it is still really bad and difficult to weed. I've tried changing the blade, readjusting the...

My gerber envision cuts sandblast resist rubber and vinyl perfectly at first and after a while it randomly jumps ahead and cuts unpredictable and just a letter here and there. My only idea may be that the information isnt getting communicated between the plotter and the computer?? Any ideas...