drivers

Recently I installed FLEXI22 to work with my Roland printer, and HP 64 Cutter. While trying to install and connect the HP64 cutter, first I noticed that it wasn't even connecting to the computer - drivers had to be updated which I managed to get from the SUMMA website...

Goedemorgen, ik ben mijn installatie-cd kwijt nu heb ik de volgende stuurprogramma's netwerk en programma cutserver die me hiermee kan helpen Ik zou je daar heel erg voor bedanken.

While moving, I dropped my old laptop with xp and misplaced the cable connector from parallel to my laptop. I used coreldraw 12 for all my cutting. I tried creating a virtual machine with XP on my PC with windows 10 and now cannot get communication between computer and cutter. I bought and tried...

Hi Guys, new here so sorry if I get anything wrong. I am trying to get hold of an HP L360 driver for Onyx Productionhouse 11.1 but Onyx has discontinued support. I have found drivers for 11.2 in a previous post but unfortunately, these don't work. Alternatively, if anyone has the patch to go...

Hello, I am new here and I need some help about this cutting plotter. I bought a ColorCamm PNC-5000 few month ago because it was quite cheap, but there was not the CD-Rom with it, so, I was wondering if somebody can help me with the drivers and the software. I made many research but almost every...

I have purchased a second hand GCC Expert II with no driver disc. Website will not allow download as registered already. Have looked verywhere on the web without luck. Any help or suggestions appreciated. Thanks. Paul.

Hi there I am new to this vinyl stuff (actually I have yet to cut anything out) ok maybe not so true..I have cut a few things out..but nothing cuts out right... I have a master xy300 (yes I know now) anyway lets get past all of the should of's if I only could.... I draw in corel draw 6 (I would...

This partial wrap is 4 years old. We used Oracal 3751 with 290 Laminate. Both sides of the vehicle were printed and installed from the same rolls of materials. Installed using the same technique. Driver's side is wrecked, passenger side looks like normal wear-n-tear after 4 years. Anybody got...

I have a GCC JAGUAR III JA-101S. I have not been able to get a hold of support through their GCC club dashboard. I downloaded the drivers through the dashboard though and there is no selection for the version III JAGUAR just Ii and iv. When I attempted to load the drivers for the other...

I just acquired an old Graphtec FC2100-80A. It still works as far as the front panel cut test. I have a system with XP on it that I was hoping it would be able to use, however I cannot find any kind of a driver for it. When the FC2100 was new did it come with some CD or installation disk? Is...