• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

fc8000

  1. Graphtec plotter isn't accurate and not joining

    Hi everyone, Just a quick question, I use my Graphtec FC8000 for cutting around my Motocross templates but when the machine comes to finish its cut the shapes haven't joined the best from when the blade started and finished the cut but only very little. How would I improve this? Simple...
  2. Graphtec FC8000 cutting strip

    Hi guys, Does anyone have any suggestions on alternatives for the cutting strip on our FC8000? At over $50cdn each time they're an expensive consumable.. Thanks, Steve
  3. Graphtec FC8000/Flexi 10 Issue...need advice

    I have recently started working with our FC8000 again and thru a fairly enlightening but mostly painful bout of research and trial and error have gotten to the point where it will read the crop marks and cut prints from our HP L25500 just fine. However when I go to do just a cut job the result...
  4. Trouble reading Reg mrks FC8000,HP25500, Onxy RIP and Ideas!

    Producing art work in Illustrator CS4 and or 5 Producing Reg Marks with the plug in Cutting Master 2 (Graphtec) Artwork sent to Onyx Rip Then to HP L25500 Trying to cut with my FC8000 Graphtec. It seems as though a lot of Graphtec users have this initial problem of the sensor not reading the...
  5. FC8000-160 bad corners

    So we have finally gotten past all our problems with our FC8000-160 except we can't figure this one out. We have tried a new blade, got a new cutting strip, tried different setting (messing with overcuts, tangent emulation, force, circle resolution), updated the firmware and cant find a...
  6. Plot/cut a film that does not have a backing material

    How does one cut a film that does not come with a backing material? I have a Graphtec FC8000 and I would like to cut a .0006" thick polycarbonate film with the cutter but the film does not come with a backing material. How do I work around this?
Top