I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Apologies for the lengthy post but I know there have been a few posts on the Y Position Error on Graphtec plotters from time to time and I wanted to share this hoping it may help some of you that encounter this problem. I feel your frustration! Good news is, your plotter might just be dirty and...
I'm looking for a Graphtec FC7000 display I think any size of machine is the same but I have the 160. My machine works but just needs new display. Please let me know if you anybody has one out there.
Brady@reddogsigns.com
970-686-1208
Hello, We have a Graphtec FC7000 that is suddenly acting strangely. The head that holds the cutting blade is moving up and down on its own accord.
I called Graphtec Tech Support and they said this machine is not longer supported. The tech suggested that from the sounds of it my solenoid in...
I have the SW q130 plotter that is the same as the fc7000. Because its the OEM version it will not work with Onyx rip and cut.
I'm trying to flash the firmware and install the fc7000 firmware, I believe that this is the same machine despite what graphtec
would like me to believe. Has anyone...
Okay, we use wasatch to print to my Epson and cut to my Graphtec FC7000. We were cutting fine yesterday afternoon but when I got here today the Graphtec is cutting off about an inch to inch and a half to the left. Called Graphtec and they couldn't give me an answer they also said it was not the...
I just purchased a used Vinyl Express Q100. The previous owner only told me that he replaced the original blade holder with an aluminum one. After searching a bit, I believe that the holder is a Roland one and the extra blades he supplied me with are Roland blades.
My question is how should I...
I have my vector design in illustrator & want to half-cut stickers & perf cut around the whole group of stickers. The media is plain & not printed on so I have no registration marks to be recognized. How do I set up Cutting Master to half-cut AND perf cut the same document all without having...
I am having a 3-4 seperate artworks of around 6 x 6 inches to be cut on a 2 feet wide vinyl. But when I cut them on my Graphtec FC7000 using Felxi Pro 8.1, each artwork is cut randomly in small areas. The plotter cuts a part of 1st artwork, then it reaches out for the 4th artwork in the series...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.