• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

roland xc540

  1. Xc 540 head clunking

    It seems to coming from the cutter potion of the cut carrier, If I separate the cutting potion from the printing potion and manually move the cutter across the length of the printer I can feel a clunking noise and feel it in the head. I will attach a video. It doesnt do it constantly. but i keep...
    • awalracing
    • Thread
    • clunking roland roland xc 540 roland xc540 xc540 xc540 roland
    • Replies: 10
    • Forum: Roland
  2.

    Need Help Help with Roland Soljet 3 XC540 - head and print issues

    Hi Everyone! I need help troubleshooting my Roland Soljet 3 XC540. In the attached picture is the first test print where the print issues were in C only. We flushed the lines for light magenta and got some clumpy ink out. Pulled clean ink through the damper, it still wasn’t working. Flushed the...
  3.

    Need Help Roland XC540 RIBBON CABLES & SCAN MOTOR ERROR HELP REQUIRED

    Hi been having an issue with our Roland xc540 get scan motor error code 0090 0080 however ive noticed its due to the ribbons getting caught.. they seem very loose / slack prints will run but then they get caught and it will show up with the error.. I am sure they are not supposed to look like...

  4. Roland XC-540 not printing crop marks

    Good afternoon, I have searched everywhere for help with this, to no avail, so I'm coming to the Pros! I'm trying to Print, Laminate and Cut. I have enabled Print Crop Marks on the dialog in VersaWorks, made sure it's Print only and sent. Went it goes through the printer, it won't print the...
  5.

    XC540 - Help needed- Changed 2 print head and now it is printing like the attached...

    This is a test print from the Roland XC540 Pro III - I had changed out the LM and LC Print Heads, replaced all of the card cables between the Head Board and the Carriage board and the Carriage Board and the actual heads. The heads that were giving me a problem are performing beautiful, as well...

  6. Roland xc540

    Roland xc540 HELPP COLOUR PROBLEM Hey Guys, I have a Roland XC540 and the problem I'm getting on every prints is too much Megenta, I tried every different profiles but no luck. Is there anyone who can send me a profile that will neutralize the photo or even give me advice. Regards Ketan
    • K3TZ
    • Thread
    • Replies: 0
    • Forum: Roland
Top