Recent content by utmtech

Not that the following link has any credibility, but whoever wrote the article(ette) is claiming aqueous pigment aswell. http://www.coolhunting.com/culture/woodsnap That said, I have a VJ1204 I am very heavily considering modifying into a flatbed printer flowing bordeaux latex through a DX5.

I have had really good luck with Bordeaux ink sold by premiercolour. OEM inks are not going to save you from the 1/1,000,000 strike of bad luck where some component like a seal fail and allows pressure to drop or what looks like build in this case. Others ragging 3rd party inks are of the same...

Thank you!

Interesting, thanks!

Is there a specific crack card you would suggest for locked DX5 heads? And can you confirm the water-based heads perform OK on solvent ink?

I have a water-based DX5 epson head in my 9800 that I was considering swapping into my Mutoh VJ1204, who all has actually done a similar swap? Are the solvent DX5 heads not "locked", but the water based ones require an unlocker chip? Will this work within spec and produce like quality?

As does mine, but on my other fw it would not reset on the init count reset. It is clearly something that was patched in later fw.

I have seen this error when the wiper blade gets bound up. This can be observed with that cover off and assuring the wiper fully rests to the right after a cleaning cycle. Either needs grease or is out of alignment.

Dear lord, you haven't done any P.M. on this, ever have you? You need to clean this mess off before you do anything, I can't even tell what I am looking at... It looks like you removed the inside track from the capping station which has the safety on the side. That isn't supposed to be removed...

[QUO TE=graphicwarning;1215369]Reminds me of this one... FFS >_<

Remove far right side cover by removing 4 fine thread metal screws, 2 course thread plastic screw, and 1 orange handle. Remove two screws from the end of the capping station. Disconnect all hoses from the bottom of the capping assembly (3 total) Remove capping station. Observe T shaped...

I do all window decals with a wet application, is this a known issue?

" # of Printheads: 312 (52 each cyan, magenta, yellow, black, light cyan, light magenta)" FTFY

I have been using Premier Colour to order transparent 2-mil vinyl, and Bordeaux solvent ink for my Mutoh. The company has been awesome to deal with, and the Bordeaux ink has performed as good if not better than the OEM I was buying for less than half the price. NO issues in my DX5 head. ~JayCo...

If you get the 1304, go ahead and get some new dampers and lines from ebay. Also buy some mutoh solvent cleaner and a solvent resistant syringe.