Search results

Of course, you can try, but imho it's a waste of time, you may make it much worse than it is now. Sometimes required changes are very subtle, sometimes you have to do the full rotation of the valve screw - that's why the gauge is required.

To adjust the meniscus vacuum you need a vacuum gauge connected to the vacuum tubing with the T connector. There are two parameters to be adjusted: - meniscus setpoint (value, which should be maintained in the system) - time required to change the meniscus value from maximum to minimum (vacuum...

Ink can drip from a single head or colour if the vacuum filter is blocked. If all heads drip, the reason is somewhere before the meniscus vacuum manifold - connectors, valves, tubings, pumps.

Drop size matters, of course, but it depends on what you print, which substrate, and so on. I don't deny that the 4 pl droplet provides good details.

I was trained in Inca Digital at Cambridge as a service engineer a few years ago. Does it count as "any experience"?

Remove the corrugated and put the acrylic on the table - that's all. In my first post, I wrote that I knew the cost difference. And I know that 15000 sqft/h is more than 4000, so it's not "the most productive true flatbed". That's my point.

Well, the former Inca Onset X3HS (now it's Agfa Onset Grizzly X3HS) is also a true flatbed and its printing speed is up to 15000 sqft/h (1450 sqm/h). It's a little bit more than your 4000 sqft/h... I don't want to compare these two printers, as Onset is probably much more expensive, but "the...

A few years ago I did an ultrasonic cleaning of the heads taken from the Fujifilm Acuity (the same model as Oce 360GT). 5 heads were cleaned, each with at least 5 missing nozzles. All nozzles were recovered. All these heads worked after the cleaning for a year (they all collapsed within one...

A few years ago I did an ultrasonic cleaning of the heads taken from the Fujifilm Acuity (the same model as Oce 360GT). 5 heads were cleaned, each with at least 5 missing nozzles. All nozzles were recovered. All these heads worked after the cleaning for a year (they all collapsed within one...

Draining the coolant system is a part of the head replacement procedure, so if you want to follow it, you must drain the coolant. Of course, you will do whatever you want.

Switch off the printer and try to reconnect all communication cables inside, maybe there's a lack of contact. If it won't help, I guess you need a technician to diagnose/fix the problem.

Maybe if you print just with a single channel (i.e. C), there will be no problem as other channels won't receive any data?

Looks like an internal data transmission problem. Try to rip a picture using only one pure colour (one of CMYK), maybe you'll find, which channel has a problem.

Did you check the heads calibration?

Are you sure that anything is missing? I would say that the shaft should be locked somehow to prevent such situations. Some Seeger ring? And what did you use to make these photos???

In the case of the GT version (small table) de-installation and installation are not a big problem - the most important part is to prepare the printer for shipment (lock the carriage to the gantry, gantry to the table and remove fluids from the printer). Skilled service engineer will need a few...

Print the nozzle test?

Sprawdź płytkę zczytującą RFID z worków, być może ona gubi zasilanie albo po prostu czytnik na tym kanale jest uszkodzony. Być może też odległość między płytką a opakowaniem jest zbyt duża, czy jak dociskasz płytkę, system wykrywa opakowanie? Próbowałeś zamieniać miejscami płytki czytników...

Usually special software is required to backup and restore parameters.

And you don't have any initialization errors?