Search results

If I dropped my two year old child from an eleven foot deck and he bounced twice off a net before falling I would have been over that fence so fast I may have caught him. If not I sure as hell would have protected him as long as I could...

Still no power here. Monday 5 pm. At the mercy of the wonderful JCP&L. Wonder how my print heads are after not firing for a week... :cool:

Your not alone. Here's a three page thread about it and there are many more when you do a search. http://www.signs101.com/forums/showthread.php?t=56661&highlight=versaworks

Look at the Sheeter. Line it up and crank away. (Don't do it like the video) Mask a 10ft. piece in about 5 seconds bubble and wrinkle free. http://weedersheeter.com/

Probably this one. http://shop2012.yellotools.us/Cutting/Knife-Cutter-Scissors/BodyGuardKnife::1216.html

And if or when it fails they will offer to reimburse you $8-$10 an hour for removal...shop rate right? LOL

I've started threads and posted about the Avery issue and their business practices many many times. Avery can't be trusted at all and when it happens again the end user will get screwed again; just look at their history...

Same box I bought when I was at Butera in 88'

Hopefully you charged it. Call your CC company and dispute the charge.

Oracal makes the Solvent printable reflective 5600 but it's not available with Rapid-Air. .

Vinyl that bad you need to plow not pull. Heat gun, torch, steamer, hot power washer... Tell them no... :noway: pita

Cut it straight down the edge of the overlap, seal it down and hit it with the torch.

Gerber Edge or Summa thermal transfer printer for bright spot colors.

Electrical storm

I buy all my blades from here. Work well and last long. http://www.cleancutblade.com/

Tell your customer you have a 2 dozen minimum.

I've outsourced a few billboards larger than that from a reputable company/ merchant member here on this site and if I remember correctly it was 13 oz. material. Not sure of the denier count but they specialize in this so I trust the product. Proper installation is key of course.

Too high of a heat setting most likely. Lower the heat first, try a different roll. If it doesn't print any better clean the encoder strip.

Check here http://www.hooksandlattice.com/signage.html

Blue krylon fusion.