Search results

Most of the time it is not the wiper motor, but the slider on which the wipers are mounted. Try to clean the rails.

Looks like that your print head have problems. How does the nozzle test looks like?

Can you cut so precise that you find the exact point to cut between the images? So that you don‘t have the last half millimeter of one picture at the edge of the other? I‘m shure that is more stress than making two cuts. Even expensive automatic XY-Cutter have two knifes for the middle cutters.

Would not. The ink type is written on the chip.

A platen heater is neccessary. There was a pre-pre-predecessor of the Valuejet, the Mutoh Rockhopper I, which was introduced with the first Generation eco-solvent ink which was not suitable to print on uncoated media. This machine had a pre-heater at the media inlet, and a drying heater at the...

For an upgrade, the w-models were available without reading ink chips, as far as I remember. The bigger problem will be that this printers have. o print heaters.

Whole cutting head. The cradle isnt available separately.

Very good pricing when considering the value of the cutter and the software.

Could it be that you yellow ink is expired? Or have you stop using this printer for a while? A yellow which is too light is often a problem of settled pigments. Shake the cartridge gently and than print a few meters to print the ink which is in the tubes ... could help.

The IP-Adress of a SP540V isn´t accessable through the printers menu. You need a software to configure the printer. If you don´t have the original CD what is coming with the printer, you can download the Intercon-Nettool from this adress...

You‘re right. How you describe it, the technician is responsible for the damages.

Have been a service technician for roland for years, and have never replaced the linear bearing where the carriage slides on, never had a worn bearing. If the sound of the movement of the carriage gets louder and louder, it is more likely the scan motor.

I‘m a service technician too. As long as I do not destroy parts negligent, the customer is responsible for the costs of searching for errors. But I explain that to the customer.

You haven't bought Flexi, you have bought a license to use it.

Unfortunately yes. But of course it dont need to be the same at your machine. One time, an incorrectly plugged cable after a print head replacement causes the same issue.

Had that too sometimes with customers printers. Have never found the cause, even when replacing the mainboard sometimes.

A sample based on a versacamm: http://www.chiericati.com/plotter/flatbed_roland_vs-eng.htm

Some years ago that kind of printers based on Rolands can be seen from several mostly little manufacturers, mostly moving the printer over a table. Roland themaelves have done it with the lej640ft. https://www.rolanddga.com/products/printers/versauv-lej-640ft-flatbed-uv-printer Eco-Solvent...

What are the ink limits of the profiles you compare with? I for myself have set ink limits below 80% as doubtful for good colour quality.

If you was able to create a profile with Flexi 12, than there is no need to send a profile to me to test it. Grey: shure you check your samples under correct light conditions? Colour is reflected light, and ICC-calibration is based on light near daylight. Viewing colour samples under artificial...