• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Search results

  1.

    Why yes....yes I did.

    Wrap That thing is so cool... Nicely Done Sir...

  3. New Printer 1204vj Lovin' it so far!

    Flushing Most likely reffered to in the MENU as Flushing, sometimes depending on Firmware it may be called Spitting...

  4. Mutoh maintenance station / Cap top?

    You need a new Maintenance Assy You need a new Maintenance Assy...
  5.

    Vertical lines in print not consistant 1204

    Vertical Banding Slow the Carriage Speed down... Some colors, usually lighter colors when printing you will see this anomly. It is a profile issue in regards to CR Speed. Use a profile that utilizes a slower Carriage speed...
  6.

    VJ 1204 Banding problems.

    Page Feed Menu Right to Media Type 1 Enter Down to Page Feed Set to 250mm Enter on Test Print 1 Measure Enter adjustment if off Enter to save Exit to Ready to Print

  7. the worst vertical banding ever

    Avery has been having that issue for a month or two with that media, try a different media and the issue should go away if the printer is dialed in correctly. I had the same issue on 2 separate 64s, different media and the issue was gone. Avery is aware of this, we sent them samples...

  8. Cutting errant "v" notch

    Cutter Issues Bad/worn out blade holder... Grooves in the cutting strip... Bad Blade... One or more of these three things cause what you have described

  9. carwrap.com?

    carwrapcity.com Try these guys, I am impressed with the work they do... http://carwrapcity.com/

  10. china printers

    Chinese Printers ALL, I repeat ALL Printers made in China that I have used/tested have been complete Junk with NO exceptions...

  11. Replacing Maintenance Station - Have you?

    Maint Assy Go OEM... That is all I have to say about that...
  12.

    Thoughts on what's causing this?

    Media Issue That is a problem with the media...

  13. Error Code: E126 for Mutoh 1608HS Any Idea?

    PG Motor Circuit PG Motor, Sensor, Mainboard... Troubleshoot from the motor back to MB

  14. How to load 54" media into a Mutoh 1204 / VJ48

    My 1st question would be why would you waste media like that, just buy a 54" Printer... I see tons of PF issues happening by doing this... I just don't see the point, 50" media is available form all media manufacturers... The machine will only print 48" maximum... I just don't get it...

  15. Avery Chrome Wrapping Film Questions

    Avery Chrome See the Vette wrapped in Avery Chrome

  16. Shovelhead

    Prayers My prayers are with you Sir...
  17.

    New Mutoh 1204 solid color issues

    Heater Temps From the Printer Options Tab in the Production always adjust temps here... I always check mine before a new job...
  18.

    New Mutoh 1204 solid color issues

    Heaters That is most likely Heater Settings...
  19.

    3M Media

    Wraps Thanks for the compliment. We tend to use Avery as much as possible, hate that we had a bad experience with the 3M film... We have never seen anything like this and I feel like it is most likely an isolated event, at least we hope so...
  20.

    3M Media

    Ferrari I can't answer that because it might incriminate me....
  21.

    3M Media

    Ferrari Wrap Before and After Before & After
Top