Search results

Thanks for all the suggestions. I've tried them all to no avail. I even hooked up a second monitor and increaed the desktop space as much as possible, and still could not find it. I did find some temp txt files, however. Looks like the next step is an uninstall, and reinstall.

Cleared Preferences - no difference. Ctrl I is for DesignCentral, E is for DesignEditor; still does not display. Switched workspace to each one one at a time, still no designEditor Thanks for the help, any more suggestions?

Help! Somhow I've lost my DesignEditor window. It just didn't show up on the last opening of Flexi. I've tried clicking the icon, and it does do its button in/out look, but no window ever opens up anywhere. I've looked on the Desktop, in memory, withing the Flexi toolbars, etc. No luck...

Just print it!

What was pimped? sorry, I don't have one, and can't tell from the photos. It wasn't wrapped by Sergio, was it? PS: next time I'm headed to LBI, I'll stop and take a look, OK?

You can always clean the pads with some solvent cleaning fluid, and dry between two towels. Just replace the pads and get back to printing.

The pump creates a vacuum, causing ink to flow from the cart, to the damper, to the head, to the capping pad, to the pump, to the waste bottle. If your capping pads are soaked right after a cleaning, the pump is not creating enough vacuum to suck the ink all the way through the pads. If they...

If the sponges in the capping station are touching the heads, the ink can cross between colors within the same head, especially if one cartridge is full and the other empty. Take a look at the color of the ink in your dampers. Each one should be pure in color to its ink cart. I believe...

Glad you decided to stay. I for one appreciate your posts, and find them helpful and truthful.

I use the following settings for force: vinyl - 18 laminated vinyl - 26 cling - 20 heat transfer material - 22 After setting my blade depth, I did a test cut on a piece of each material to get to these settings. Make sure you have the latest firmware; I had noise problems and...

And the one your Mother gives you ........

Welcome from South Jersey!

Here is the page from the Service Manual on undefined media errors.

There are also system fonts you don't want to mess with.

just a thought, but did you double-check the electrical connections on the carriage? you may have knocked the sensor wire loose when changing the heads, or nicked the wires.

Are you sure your right side alignment is in the center of the row of holes? Check the manual for a picture of where the material needs to be in relation to the row of holes, if it is off by 5mm, you will get an undefined paper error. If the paper is just slightly cocked, you could print for...

Disconnect the pump to capping station lines, and pull your vacuum from the capping station connection. Manually push the head as far right as possible and hold it there while pulling the vacuum. If there are no leaks in the lines or damaged heads, you should have ink flowing in no time.

Matt, Make sure he realizes the difference in cost per square foot between a Gerber and solvent printer.