Search results

Too much pressure and not enough blade can cause premature wear of the blade holder. This happened on my cutter and it would not cut deep enough on one side.

Your cutting speed could be too slow, allowing the material to buckle under the blade and pull up from the cutting strip.

If you end up doing this job. Do not give a warranty longer than 30 days. Elastomeric Masonry, Stucco and Brick Paint is like a condom that you paint on. Holds in moisture and keeps moisture out. That paint will stretch and contract in high and low temps. Your best vinyl will stick to it but not...

Newbee

jci44708@yahoo.com

jci44708@yahoo.com

Get the seller to demo the cutter on the vinyls you use and take notes on how they do it.

Home Depot fot the Chalk Board paint, just roll it on the wall or a sheet of good plywood. Magnets? What size? How many?

Had the same thing happen on a Seiko W64. Did everything but pull the skin off my face. Turns out it was the scan motor. Just wore completly out. Found a NOS online and works perfectly. Mimaki bought Seiko for the technology and discontinued parts.

The XR-640 is a great printer. I now have two of them, both bought used. I print roll to roll on them both and cut everything on Graphtec cutters. 6mil vinyl and .030 magnet.

The head unit must be hitting something for the unit to seperate. Check the edge guards, make sure they are flat.

Cut four crop marks from old white vinyl prints (see attached photo) trim them at the red lines I have drawn, then align and stick them on top of the marks on your Red Glitter Material.

Welcome Mass Hole. Ask alot of can I and what if questions when buying new equipment that you are unfamiliar with. Alot of new technolegy is available now to make your job easier. There is hundreds of years of experience and knowledge here. We are here to help you if we can.

So, you're going to print on the HP then laminate it and then print right on top of the laminated print. Hmmmmmmmmm. Why? Will the HP latex ink adhear to the top of the laminate? And dont forget about that 220 volt super hot heater on the HP, after it prints, the material will start to shrink...

Im no expert on this, I have seem them in opperation printing on key fobs and it was amazing. But it sounds like an expired product or a UV drying problem with the gloss overprint. Personally I would reach out to the company you bought the LEF-12i and your inks from. Please keep us posted on this.

I use this process when customer wants a redeemable coupon on the back of their decal

Yikes

This is the back side of the liner we're talking about, correct?

Print the design on your Epson printer or use colored vinyl and print with No Color just crop marks. Kiss cut the design on your Graphtec cutter, Weed it, then transfer tape it. Done.

Maybe Change your blade. It might not be sharp. Its dragging not cutting.