Search results

Can anyone tell me or send me a link on how this is done please. I was told here is a way to do it through service menu and also manually and this is hopefully my last step to getting my unit going and back to work. Thanks.

Like title says, I've recently switched from third party inks back to Roland because the third party had issues. Black appears gray and the cyan and yellow are not even there. Any help would be appreciated. Also had replaced the manifold due to a broken nipple. Thanks. Unit is a SP-300V

I'm a bit stumped on this one. Customer wants me to place a logo on his plastic ice chest on printable media. The surface is pretty bumpy. Any sugestions? Thanks.

Hi i have recently replace the dampers and o rings in the brass fittings in my machine to address an issue which would cause my lines to get air. I started printing but I see that it has some cross contamination. It will only do it once the machine starts pringing then goes back to normal. If I...

Have a customer that wants some graphics on a his 18 wheelers just thought I'd ask the experts in here for a bit of help on what I should charge. The "A" in the graphics would be done on my digital printer the res would be on the cutter. I will be making the Assured Logistics on both sides as...

Any suggestions on how to get rid of these? Thanks.

What are the symptoms of a pump going bad on a SP-300V? I have a problem that I syphon the ink out through the dampers and my machine will print fine for a few then ink fades and stops printing. Dampers, caps and wipers are all new and have just been installed and I'm wondering if it may be the...

Well today my magenta stoped printing in my SP-300V. I had Solaris ink and went back to ecosol max and still doing it. Tried sucking some of the ink through the lines as per a thread I found when searching the forum, to no avail. Any ideas? Tried solvent on the caps. Didn't work. First pic if...

Well long story short, my computer took a dump so I got a replacement. After installing all software I noticed that the yellow is now printing orangish. How can I correct this? Unit is a Roland SP-300V and running of versa works 2.00. Any info I left out, please let me know. Thanks. in advance.

Looking to add a new piece of equipment at our shop and ran into a used GX3000 printer by Graphtec. Does anyone have any experience with this printer? How available are the inks and what are pros and cons. Thank you very much in advance.

Hello I have a question which I did a search for but found no solution. I just upgraded to a vista computer and installed Lxi8 coming from Lxi6 on the old computer. Several of my saved work has fonts which the lxi8 will not recognise and I'm having a hard time finding the fonts on the old...

Hi I've been doing decals for a while now but mostly stripes and other shapes with words and what not...simple stuff. I've got LXi 8 software which I am told is the same as Flexi and wanted to know how does one get a start on vectorizing with this software? Any tutorials out there or any tips...