Search results

We are implementing the new ONYX Thrive system into our entire print network sometime in the near future. I have concerns with switching the system for the CET. I was told that the print driver for the FK512X was only applicable with Window XP. However, according to the ONYX website, it says...

Hello all, My CET FK512x flatbed running Onyx 10 randomly scatters black hash marks along the y-axis origin. They fall into prints and cause some trouble on the products we produce. It does not do it on every bed, and it is never consistent. The marks can sometimes vary in length and spacing...

So I begin printing my first bed today and after 6 inches yellow cuts out, but not completely. One of the two heads is firing every other column of nozzles. I saw that "artbot" had addressed this issue months back, except his was only half of the head doing so. I disconnected the data cable to...

After today's experimentation, I discovered a few things to add to my previous post here: Mind you, this is all regarding printing a very rich RED. If I print this full sheet of red at 4 pass, bidirectional, on 720 I can make it all the way through without dropout. Of course it looks like crap...

I have a motor that has been going bad for the shutters. It randomly stops working and leaves dark bands of ink. Where can I get a replacement motor for this?

To any of you ONYX and/or CET users out there: How do you guys usually save your files for print? What kinds of formats have you used? What problems with certain formats have you had? What resolution do you save files to? Any do's / dont's when it comes to preparing files that have had great...

I have been running this CET FK512X for a year now. I still cannot seem to smooth out my banding. So, I have provided photos of each color with the fastest print speed so you can see the density difference between bands. As you can see from the photos, The first half of the second pass of...

I really would like to figure this one out, I have a run of 45 4x8 sheets that have 4 one inch regions of print that should only take about 5 minutes if it would advance. I have to let it print nothing for the entire sheet basically for 35 minutes. Any help appreciated! Nick

[THIS THREAD IS OPEN FOR ALL DISCUSSION AND BRAINSTORMING] This is something I am seriously researching. #artbot...You may want to look into this as well. I want to custom cut a reflective half inch thick clear plexiglass back laminated with a chrome film. I will have holes drilled to fit in...

I have a couple heads that spray so much ink that the ink condenses on the bottom of the head and covers the nozzles causing dropouts on the print. Where should I start?

I am having issues keeping my print heads aligned on my CET. Some of the heads will jump as far as 7 points offset after a couple 4x8 foot sheets that were printed immediately after an alignment. I could do alignment after alignment and have changes average 1-4 points consecutively. :banghead...

https://plus.google.com/u/0/photos/113755269332254012877/albums/5815532908112640465 Shoot any questions you have for me. I will be more than happy to share. ENJOY! :rock-n-roll:

I am seeking direction in adjusting the voltage and temperature settings to fix the appearance of the nozzles. When I have a little more time I feel that K1 could really use a good solvent flush to straighten the firing direction of the ink. Any advice? Sorry, I realize the photo is not the...