apply

Hi all Till now we used to make really small stickers ( 5x2 cm and smaller ). Now we have a customer who needs 10x10cm decals. Before taking the order I would like to understand how those should be applied properly. We print eco-solvent ink on Oracal 3461 white vinyl and the decals will be...

comes in a little tin can, apply with brush to bond two layers of banner together...? thanks!

So right now my current process to apply the vinyl is print, cut, apply. However it's very difficult applying the front wrap after the vinyl has been cut. It's pretty weak around the numbers. (see pictures) The vinyl can stretch, wrinkle etc. I'm pretty good at it and very rarely do I make a...

I typically like to sleuth these out on my own, but I'm up against a deadline on a rush job. This is the only pic I have and I have to cut the vinyl for the customer to apply on the trailer, which is on the other side of the country in Washington state or somewhere. Thanks.

I'm looking for where to find or what manufacturer sells two-sided cold lam film- So I can apply to inside of windows facing out. Canadian suppliers preferred. Thanks!

We make large format cut-graphics (not printed) vehicle stripes that are precut and end-user installed. They are not wraps an most are wet apply. We were using Oracal 951, but our customers were having too many install errors (bubbles, wrinkles, etc...) and we had a couple quality issues small...

I cut and apply a lot of sandblast stencil to cedar signs so they can be sandblasted and painted, etc. But I have been having a hard time finding an application tape for the stencil that works really well. I started out using regular Conform 4075 RLA paper tape, but that sticks too well. After...

I have a 9' x 12' blank vinyl banner sprawled out on my concrete floor and I have 3 printed and laminated pieces of Arlon DPF 8000 to apply to this banner. Any suggestions? Can I spray it with soap and water? Or should I avoid the soap? Ideally, I'd like to deliver this banner tomorrow.