heater

Just got a Epson SureColor 60600 and have only printed 2 full rolls of White Concept 201-HTAP-60 Matte 3.4mil High Tack Permanent adhesive. After removing the second roll and getting ready to put in the 3rd, I noticed a line of residue/adhesive? on the right side of the back heater, going from...

Hello, I have a mutoh 1641sr printer and am attempting to print on a new material. Its the black label window perf from fellers. I noticed that the material is lifting up from the liner while its printing an I had to stop it because of a head strike. I already raised up the print head to mid...

Had this problem at beginning of the year temp to low, I changed print head cables as someone suggested and it went away until this week. maybe 8/9 months, even in sleep mode it will turn on and show temp to low and once in the middle of print, thats what it did before. should I turn heater...

I have an older Versacamm SP300v. It has worked fine and printed friday night with it. I came in this morning and hit test print, display said now heating and never warmed up all the way. I turned off the main power, waited, still same. Checked the 2 main fuses which were good. In the menu...

I been having lot of issues with my Oce Arizon 350GT since last week. If anyone know what the INK HEATER SYSTEM PROBLEM means please reply. The ink temp say N/A, and when I try to heat it just says INK HEATER SYSTEM PROBLEM, what is that related to the motors?? Thank You

I have a 2005 SJ745EX ProII and the platen temperature will not hold at the desired setting. It always goes to the maximum. I have the service notes manual 5th edition dated Jan 06. It does not describe any troubleshooting methods for this issue. It does show the various components and they...

Hey all. Weird issue with the JV3's heater, both pre and post: It'll heat up just fine, and start printing as it should when it reaches its target temperature, but at seemingly random points, after something has been printing for a while, it'll just stop. Both the "Heat" and "Constant" lights...

Winter is here and it's getting cold. Anyone use portable heaters during wrap installs? I rent out a section of a fairly large shop that doesn't have adequate heating. Making my install not a fun experience... Does anyone have experience in this situation and can recommend a heater(s)...

I have a JV-33 160 3 years now and yesterday i saw on the display in that under the POST HEATER indicates "BREAK". Of course the post heater doesn't work. Do you knpw something about it? :help

Doing some routine maintenance, I reinstalled some hardware on the JV3 after cleaning around the heads, and my hand every so lightly bumped up against the wiring for the voltage selector, located on the underside of the machine, at the far left side. These are the selectors that allow you to...

Hi All, Been using a Mimaki JV3 with virtually no problems until yesterday. Towards the end of a print I notice the heater lights go off. No error on display. Flipped heat switch, re-booted printer, sent a new print. As it was warming up, lights go off. Display said "breakage" called tech...