I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
We all know HP will no longer make inks for the HP Latex 260. I am so angry especially since it is a great printer!! What am I supposed to do with this printer? Use it as a coffee table?
Question, I know on eBay you can buy 3rd party inks, but what about 3rd party printheads?
Hi,
I’m experiencing some banding issues on my Latex 260. Substrate is HP Vinyl Adhesive— using Sai RIP
I have completed a print head cleaning and let the printer warm up with several prints for an hour. Printheads have been replaced recently and calibration performed. I’ve attempted to change...
Hello, my l25500 was working great and after moving I am having issues.
After cleaning and reinstalling it the printer booted up fine. The ink would pump and it would feed material but the heater was not turning on and when going to test print I would get a 14:17 error about AC voltage. I...
I recently got this message when I fired up my Onyx Postershop 12. "Network I/O is limited. Anti-virus software may be blocking access. Other network problems may exist." I don't know if this contributes to my jobs being cancelled in the middle of printing. It's kinda weird, because it only...
Hello, I am having troubles printing on General Formulations 212. I don't see this happening in any of my other vinyls I print on using the same printer. I have created my own profile in Caldera and have tried some other generic vinyl printing profiles but with no luck. The cracking is most...
Hi, usually after printing darker graphics, I notice a lot of squiggly like debris on the print. I don't believe these are consistent spots. I downloaded and used the Orajet printer profile while printing in Caldera.
Printer: HP Latex 260
Substrate: Orajet 3621
What are some tips on how to...
Hello guys.
I need help with print quality issues. I simply cannot get this printer to print with no graininess. I have tried the following
Changed RIP from Sai Flexi to Onyx (Big improvement but still graininess)
Cleaned print heads
Aligned print heads
Cleaned OMAS
Calibrated Substrate...
Hello,
I've got a new setup than what I'm used to. I've used mutoh and roland printers, graphtec cutters, flexi, versacamm etc. We have just purchased a HP 260 and a Mimaki cg-160. Issue is with print and cut. I took an ink pen to some of the cuts so it may be easier to see them in the...
Just got an HP Latex 260 with the hopes that it will replace one of the Epson GS6000s we're running. We do a lot of oversized banners (anywhere from 6'-20' high by x length), so we're often tiling. The Epsons perform pretty admirably in this respect. I will see a difference in tile lengths when...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.