nozzles

I tried a flushing position adjustment in service mode but I notice there is ink now dripping out of the left side of capping station after cleanings (picture1). So when I did the flushing position adjustment it says to press the ENTER key when the arm part of cap unit starts to move which I did...

Trying to find out which order the colors of the Test Print are in for a Roland VS-540i so I can find out which color is missing nozzles to flush with cleaning solution. Looking closely at my test print I think the Color Order is Light Black, Cyan, Magenta, Yellow, Black, Light Magenta and...

Hi, I'd really appreciate some help or advice. I noticed some streaks in prints, mostly when printing grey, but slightly visible in black too. Nozzle check showed some missing nozzles on black only. Replaced the maintenance station with a brand new OEM one. Performed several cleanings and...

A couple months ago I started losing black nozzles on my printer after a few head soaks and cleanings it was back to normal. It worked great for one print then just started dropping nozzles like crazy immediately afterwards. Ended up replacing the capping station, printhead, dampers and print...

Hi, all! Hope you can help. I'm running an XC-540, and when I run a test print, everything looks normal except that half of the magenta pattern just doesn't print. Anyone seen this before? Thanks!

Hi everyone, i fight with annoying banding in K and C channels while M + Y is alright. See pictures and compare nozzle check vs. nozzle pattern printed in service mode. Printhead is about 1 year old, used daily printing mild volumes. Cleaning does not help, using I2 interweaving makes things...

Wondering if anyone has dealt with this specific issue before - Mimaki JV3-130 I got the Y Current error and thoroughly cleaned and greased the bar it slides on, everything running fine, got the error again this time from the top bar it runs along, cleaned and greased that, only thing is that...